Scaled down models are widely used for experimental investigations on huge structures due to the limitation in the capacities of testing facilities, and, moreover, the experimentation on scaled models is less expensive. Also small scale models are often built with materials dissimilar to those of the prototype. However, only few studies have been carried out on the similitude laws for the prototype structures with small scale models built with a different material. In the present study, an attempt has been made to develop a scaling law for models to carry out the free vibration analysis of structures, based on the similitude requirement. The established scaling laws are validated analytically using simple test problems. The similitude relationship between the prototype and the model is validated with the aid of a case study using finite element analysis software.
12 November 2016 in Journal of Mechanical Science and Technology
Numerous biomaterials are used to fabricate bone scaffolds to repair the bones subjected to trauma. The scaffolds are fabricated with interconnected pores with 40–70% porosity to facilitate the entry of the cells that ensures rapid bone formation. In
1 January 2016 in High Temperature Material Processes: An International Quarterly of High-Technology Plasma Processes
In this paper, an attempt has been made to enhance the macrostructure characteristics such as deposition rate, weld thickness, penetration area, and hardness by using a flat wire electrode and by optimizing the welding parameters. For this, an experimental study has been made. The welding parameters such as the welding current I, welding speed WS, and the orientation of a flat wire electrode θ that influence most the weld bead performance are considered, and the other parameters are held constant. The welding was carried out by using the L9 Taguchi technique. The performances of the weld samples are analyzed, and the macrostructure characteristics are measured. The signal-to-noise (S/N) ratio and analysis of variance (ANOVA) are applied to study the effect of welding parameters. The results obtained by using the S/N ratio match closely with ANOVA. It is inferred that the orientation of the flat wire electrode and welding current are most influencing parameters. Multiple regression equations are also formulated for verifying the macrostructure characteristics.
This paper proposes a flat wire electrode technique in the flux cored arc welding (FCAW) process. E70T1 electrode was selected for the study. Flat shaped electrode can improve the quality of weld, in terms of mechanical properties. It also enhances the heat input and penetration. For this approach, experiments are carried out with varying size of flat wire electrodes. The result indicates that, the proposed technique of flat wire electrode can be used effectively to improve the weld bead quality. Mechanical properties are analyzed and compared with results produced by regular electrode in FCA welding. It inferred that, use of flat wire electrode in FCA welding gives 12.5% greater bending strength, 11% of greater impact strength and 8.45% of less hardness over the regular electrode in FCA welding.