Hydraulic ram pump (hydram) is a rather 'mature' technology as it has been used over the last two centuries with many variations in design and basic configurations have been tried. Pump motor is favoured rather than hydram to transfer the water from one point to another point because of its consistency. However, following the increasing awareness of the adverse impact of global warming and the needs of sustainable technology, interest in hydram for water supply purpose has revived. The purpose of this paper is to study the effectiveness of hydram implementation and the effect of the stroke valve design towards flow rate of water being delivered. There are three methods used in this study; (i) experimental evaluation of hydram; (ii) experimental evaluation of adjustable waste valve; and (iii) computational simulation of adjustable waste valve. The adjustable waste valve was designed, fabricated for experiment and modelled for simulation. The hydram is very good to be installed as a pump at hill because it can supply water more than high of inlet water. The different length of stroke shows different behaviour of water flow and more length of stroke, more flow rate of water at discharge pipe. Hydram has a great potential to be functioning as a simple and reliable pumping device in those hilly remote areas which are of no water supply coverage.
16 January 2019 in IOP Conference Series: Materials Science and Engineering
Municipal solid waste incineration produces non-combustible by-product known as bottom ash. Increase in waste production leads to increase in bottom ash, which raises environmental concerns and management issues. With the parameters and properties of bottom ash are in close agreement with those of aggregates used in concrete making, bottom ash has been adopted for reutilization in civil engineering. However, the workability of the concrete made with partial substitution of aggregate with bottom ash from local municipal solid waste incinerator has never been addressed. This paper aims to evaluate the performance and properties of concrete cube made with partial substitution of aggregate with bottom ash from Pulau Pangkor municipal solid waste incinerator in Perak. The content of bottom ash substitution in concrete cube made in this study were varied at 10, 20 and 30 percent of aggregate. All samples were tested for its workability, water absorption, compressive strength, and resistant towards fire. It was found that the performance of concrete with partial substitution of aggregate with bottom ash reduced with increased in substitution content in all aspects. However, the performance of the concrete with 10 percent bottom ash substitution to aggregate was acceptable and closed to that of control concrete. It has been demonstrated through this study that the use of bottom ash as partial substitution of aggregate in concrete making is possible at very low content. However, there are huge needs of further enhancement in manufacturing methodology in order to produce concrete with partial substitution of aggregate with bottom ash that outperform – or in closed agreement with – the control concrete.
The present study reports the anisotropy effects of uniaxial and multiaxial loading on cancellous bone in order to mimic true physiological conditions as well as pathological reactions and thereby provides improved data that represents clinical and real life conditions. Cancellous bone samples were CT-scanned for morphological analysis and model construction. The models were then computationally loaded on three different directions; horizontal, vertical, and at 45°. Lower BV/TV, Tb.Th, and Conn.D resulted in lower number of cycles to failure, regardless to the loading conditions. However, the number of cycles to failure was found to be negatively correlated to the value of structural model index. Dramatic increased in effective plastic strain and decrease in cycles to failure were demonstrated by the cancellous bone models under multiaxial loading. The reduction of fatigue life was five times lower in multiaxial condition in comparison to the fatigue life under uniaxial loading. Off-axis orientation effect on the fatigue life of the trabecular bone was demonstrated the worst in horizontal trabecular bone model. Effective plastic strain was recorded the highest in horizontal model, while the model at 45° demonstrated 1.6 times higher effective plastic strain than the vertical ones. This is due to several numbers of thin trabeculae which are susceptible to fatigue at higher stress concentration. In conclusion, the anisotropic effect of uniaxial and multiaxial loading onto the mechanical behaviour of bovine cancellous bone was demonstrated throughout this study. It is apparent that multiaxial with off-axis forces are important to be considered as the loading direction manifests the fatigue lifetime of cancellous bone.