With lightweight, multifunctional, and designable characteristics, porous/lattice structures have started to be used in aerospace applications. Porous/lattice structures applied in the thermal management technology of aerospace vehicles have attracted much attention. In the past few years, many related numerical and experimental investigations on flow, heat transfer, modelling methodology, and manufacturing technology of porous/lattice structures applied in thermal management systems have been widely conducted. This paper lists the investigations and applications of porous/lattice structures applied in thermal management technology from two aspects, i.e., heat transfer enhancement by porous/lattice structures and transpiration cooling. In addition, future developments and challenges based on the previous investigations are analyzed and summarized. With the higher requirements of thermal protection for aerospace applications in the future, thermal management technology based on porous/lattice structures shows good prospects.

With an increased inlet gas temperature and the homogenization of the combustion chamber outlet temperature, the endwalls of gas turbines are exposed to extremely high heat loads. The complex flow structure of turbine endwalls makes it difficult to cool some regions of the endwalls, which can easily cause endwall ablation, reducing turbine aerodynamic performance and threatening the turbine’s safe operation. In order to improve the cooling and aerodynamic performance of gas turbines, the flow structure, heat transfer and film cooling characteristics of endwalls are analyzed in depth in this paper. This paper summarizes and analyzes the development of the aerodynamic heat transfer and film cooling of gas turbine endwalls in terms of geometric structures and flow boundary conditions and also presents new research directions. Based on the literature, the development and challenge of turbine endwall film cooling are also discussed.

This work primarily focuses on a three-dimensional model of flame propagation and stable combustion in a scramjet chamber. The one-equation LES turbulence model is adopted to close the sub-grid-scale turbulent viscosity terms. The finite-rate combustion model, along with the Jachimowski detailed hydrogen reaction mechanism with eight components and nineteen steps, is used to analyze the flame propagation characteristics of hydrogen combustion in the scramjet combustion chamber. Initially, based on the combustion chamber model, the effect of different injection locations and equivalence ratios on flame kernel formation and the flame propagation process is analyzed. The relationship between different fuel injection conditions and the oxygen consumption rate of the combustion chamber, as well as the total pressure recovery coefficient changes, is investigated. The research focuses on changes in equivalence ratios and injection hole distributions, with injection holes arranged upstream, downstream, and inside of the cavity. The result indicated that when the injection holes were arranged downstream of the cavity, there was a phenomenon of flame backflow into the cavity, which was related to the size of the injection pressure. For this work, the pressure causing flame backflow was approximately 2 MPa. When the injection hole was arranged inside the cavity, the relative distance difference between the injection hole and the upper wall of the cavity led to the formation of two reaction zones in the combustion chamber. When the injection hole was arranged upstream of the cavity, different injection equivalence ratios affected the final stable position and structure of the flame. Therefore, the injection position, injection pressure, and injection equivalence ratio all had a certain impact on the flame kernel formation and flame propagation process.