Reservoir rocks of the Pearl River Mouth Basin’s Lufeng Sag have low porosity (average porosity 12.6%) and low permeability (average permeability 16.5 mD), requiring hydraulic fracturing to obtain economic production of oil and gas. To contribute to the understanding of these reservoirs, and to promote successful production in the region, we analyzed the mechanical properties of tight sandstone. Moreover, we introduced the shear/tensile strength factor, in combination with the fracture toughness and horizontal stress difference coefficient, as an innovative approach to characterize the ease of forming a complex fracture network after reservoir fracturing. Based on this, we established a fracability evaluation model suitable for offshore low-permeability sandstone reservoirs by an analytic hierarchy process from the perspective of whether the reservoir can form an effective transformation volume and complex fracture network after fracturing. The results indicate that the primary minerals of the target reservoir are quartz and clay minerals, and the natural fractures are not developed. The mechanical properties exhibit a high Young’s modulus (ranging from 30.4 to 34.4 GPa) and high compressive strength (with cohesion between 41 and 45 MPa and an angle of internal friction between 31.0 and 33.5°). The relatively low tensile strength and fracture toughness values are conducive to fracture initiation and extension during the fracturing process. Through the fracability evaluation model constructed in this paper, the depth interval at 4155.1–4172.1 m is identified as a high-quality fractured layer. The results of this study not only provide theoretical guidance for target well and formation selection in the Lufeng Sag, but also have important practical implications for increasing oil and gas production from tight sandstone reservoirs.

The Sha3 member of the BZ Oilfield in Bohai Sea represents a typical ultra-low permeability thin interbedding reservoir. Hydraulic fracturing is an effective method for increasing oil and gas production. However, the complex geological conditions make it difficult to screen out the optimal frac spot. Consequently, the design of hydraulic fracturing exhibits certain limitations. A novel method for evaluating sweet spots is proposed, based on a refined geological reservoir model that considers the varying degrees of influence that geological and engineering factors have on fracturing effectiveness. This method utilizes grey correlation and hierarchical analysis to quantify and characterize the weight coefficients of each factor, ultimately leading to a combined weight coefficient approach. The results indicate that permeability and fracturing scale are the primary factors that impact the post-frac production of the BZ oilfield, with their respective combined weights being 0.33 and 0.25. The average weight for geological factors is 0.18, while for engineering factors it is 0.15. This suggests that geological factors have a greater influence on production than engineering factors. Furthermore, the correlation coefficient between the dual sweet spot index and the production is 0.96, indicating a strong positive correlation between the two variables. After comparing the predicted and actual production of each well, it was determined that the anastomosis rate is 80%. This finding holds significant guiding significance for selecting the optimal fracturing spot.

This paper describes the concept of the construction of steelmaking shop, which is carried out as part of a modernization plan aimed at creating a 21st century environmental-friendly iron and steel works, designs the smelting reduction process of producing stainless steel crude melts in a 150 t converter and presents an outline of the equipment specifications and the conditions of operation, according to the blowing conditions of 185 t smelting reduction converter of No.4 steelmaking shop in Chiba Works of JFE Steel. In the future, a rational production system will be constructed by flexible selection of raw materials in response to changing stainless steel raw material prices and further improvement in productivity and quality, making the maximum use of functions of the equipment.