The increasing presence of various organics poses significant threats to aquatic ecosystems and living organisms. Conventional water treatment methods are often insufficient, necessitating the development of powerful and sustainable alternatives. This study addresses this challenge by exploring the synthesis of ZnO nanoparticles using green tea leaves extract—an eco-friendly approach—for the sunlight-activated removal of organics in agri-food wastewater. The research examined different conditions for the removal of clomazone (CLO), tembotrione (TEM), ciprofloxacin (CIP), and zearalenone (ZEA). Nitrate-derived ZnO synthesized in a water medium (N-gZnO_w) exhibited the highest photocatalytic activity, removing 98.2, 95.8, 96.2, and 96.6% of CLO, TEM, CIP, and ZEA. Characterization techniques (XRD, Raman spectroscopy, SEM, zeta potential measurements, UV–visible spectroscopy) confirmed the synthesis of N-gZnO_w, with an average particle size of 14.9 nm, an isoelectric point of 9.9, and a band gap energy of 2.92 eV. Photocatalytic experiments identified 0.5 mg/cm³ as an optimal catalyst loading, while a higher initial pollutant concentration reduced degradation efficiency. LC-ESI-MS/MS measurements confirmed the efficient pollutant degradation and the formation of degradation intermediates. Hence, this study demonstrates that green tea extract-synthesized ZnO nanoparticles offer a promising, sustainable solution for removing herbicides, pharmaceuticals, and mycotoxins from wastewater, paving the way for eco-friendly water purification technologies.

Most countries are facing problems of environmental pollution due to toxic organic pollutants being discharged into the environment from various man-made sources. Heterogeneous photocatalysis is a possible solution for the mentioned problem, and it has been widely applied for the removal of pollutants from aqueous solutions, thanks to its high removal efficiency and environmental friendliness. Among the commonly used metal oxides, ZnO has attracted researchers’ interests due to its ecofriendly and nontoxic nature. In this work, ZnO nanoparticles (ZnO-NPs) were prepared by the precipitation method from water (w) and ethanol solutions of the corresponding metal precursors (zinc–acetate dihydrate, A_ZnO, and zinc–nitrate hexahydrate, N_ZnO) followed by calcination at different temperatures. The structure and morphology of the prepared catalysts were characterized by different techniques (XRD, BET, and SEM). Based on the XRD results, it can be seen that the synthesized NPs possess high purity. Furthermore, at a higher calcination temperature, a higher crystal size was observed, which was more intense in the case of the ethanol solution of the precursors. The BET analysis showed macropores at the surface and also indicated that the increased temperature led to decreased surface area. Finally, SEM images showed that in the case of the water precursor solution, an irregular, rod-like shape of the NPs was observed. The photocatalytic properties of newly synthesized ZnO-NPs exposed to simulated sunlight were examined during the removal of pesticide clomazone (CLO) and the antidepressant drug amitriptyline (AMI). ZnO-NPs prepared by the precipitation method from the water solution of zinc–acetate dihydrate and calcined at 500 °C (A_ZnOw_500) showed the highest performance under simulated sunlight. Furthermore, the activity of A_ZnOw_500 and N_ZnOw_500 catalysts in the removal of three organic pollutants from water—two pesticides (sulcotrione (SUL) and CLO) and one pharmaceutical (AMI)—was also compared. Results showed that decreased photocatalytic activity was observed in the presence of N_ZnOw_500 NPs in all investigated systems. Finally, the effect of the initial pH was also examined. It was found that in the case of CLO and SUL, there was no influence of the initial pH, while in the case of AMI the k_app was slightly increased in the range from pH ~7 to pH ~10.