This paper aims to investigate the state-of-the-art isolated high-step-up DC–DC topologies developed for photovoltaic (PV) systems. This study categorises the topologies into transformer-based and coupled inductor-based converters, as well as compares them in terms of various parameters such as component count, cost, voltage conversion ratio, efficiency, voltage stress, input current ripple, switching mode, and power rating. The majority of the topologies examined exhibit peak efficiencies of 90% to 97%, with voltage conversions in excess of eight, as well as power ratings ranging from 100 W to 2 kW. The existing literature has found that most isolated DC–DC converters increase their turn ratios in order to achieve high step-up ratios. As a result, voltage spikes have increased significantly in switches, resulting in a decrease in overall system efficiency. In this research, the use of passive and active snubbers to provide soft switching in isolated step-up DC–DC converters is investigated. Moreover, a comprehensive analysis of the three most widely used boost techniques is provided. A reduction in turn ratio and a decrease in voltage stress were the results of this process. The main purpose of this study is to provide a comprehensive overview of the most used high-boost isolated DC–DC topologies in PV systems, including flyback, isolated SEPIC, forward, push-pull, half- and full-bridge, and resonant converter, with a focus on the recent research in the field and the recent advancements in these topologies. This study aims to guide further research and analysis in selecting appropriately isolated topologies for PV systems.
In this paper, a switched capacitor network and a boost converter are integrated to create a step-up DC-DC converter. As a result of this converter's design, it can be applied to applications where high DC voltages are required to be delivered from a low DC voltage source to an AC inverter, such as solar power systems. The converter uses a low-turn-ratio transformer and switching capacitor network in order to achieve a high output voltage level while reducing voltage stress across the devices. Also, A primary side boost converter is used to increase the input voltage, resulting in a more rapid transfer of power. At a 30% duty cycle, the proposed converter provides a ninefold increase in output voltage. An output power of 315 W has been obtained from a topology proposed using MATLAB/Simulink with an input voltage of 35 V and an output voltage of 320 V. This converter is characterized by low conduction and switching losses, a high voltage gain along with a low duty cycle and turn ratio, as well as reduced voltage stress and high efficiency.
This paper introduces a novel boosting DC-DC converter design integrating a quadratic boost converter, an active clamp snubber, and a charge pump capacitor cell. The converter architecture incorporates a switched capacitor cell and a transformer with a low turn-ratio to achieve high voltage output levels in an isolated configuration. By employing a quadratic boost converter on the primary side, the input voltage is augmented, leading to enhanced overall performance and efficient power transmission from input to output. Operating with an input voltage of 40 V, the designed topology prototype yields an output voltage of 200 V and an output power of 100 W. A number of advantages can be attributed to this topology, including Zero Voltage Switching (ZVS) for the switches, significant voltage amplification without high duty cycles or turns ratio, and reduced voltage stress. The converter under consideration was fabricated in the laboratory for the purpose of experimental validation, and the theoretical analysis is consistent with the experimental results.