Kun Wang

Dr. Kun Wang


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 August 2023 in Materials
Verified
Journal Article
Open access
PDF file
KWKun Wang
Kun Wang
FHFeng Hu
Feng Hu
WZWen Zhou
Wen Zhou
SYSerhii Yershov
Serhii Yershov
LLLi Li
Li Li
KWKaiming Wu
Kaiming Wu
The tensile properties and work-hardening behavior of austempered bainitic steels below martensite start temperature (Ms) were investigated and compared with those of bainitic steel austempered above Ms. The results show that the tensile strength and yield strength increased from 1096 MPa and 734 MPa to 1203 MPa and 951 MPa, respectively, when the austempering temperature was decreased from 400 °C to 300 °C. However, the total elongation decreased from 23% to 16%. The martensite-retained austenite blocks and bainitic ferrite laths are significantly refined. With a decrease in the austempering temperature, the volume fraction of retained austenite decreased from 15.4 vol% to 6.2 vol%. The carbon content in retained austenite increased from 1.12 wt% to 1.69 wt%. All tensile specimens exhibited three stages of deformation in the differential Crussard−Jaoul (C−J) models. The difference in ductility is mainly attributed to the transformation of the retained austenite blocks into strain-induced martensite during deformation. The initial content of retained austenite is the main factor affecting the ductility of bainitic steels. Therefore, the work-hardening ability of austempered bainitic steel above Ms is higher than that of bainitic steel below Ms.

30 August 2022 in Materials
Verified
Journal Article
Open access
PDF file
SZSongbo Zhou
Songbo Zhou
FHFeng Hu
Feng Hu
KWKun Wang
Kun Wang
CHChengyang Hu
Chengyang Hu
WZWen Zhou
Wen Zhou
XPXianming Pan
Xianming Pan
A two-step bainitic treatment with a final isothermal temperature below MS was adopted to obtain bainitic steel with abundant retained austenite (RA). Nanoindentation testing was used to investigate the stability of RA in bainite steel and clarify the effect of RA on the deformation of medium-carbon steel. The results showed that, in contrast to the traditional one-step approach, a greater amount of nanoscale RA film was obtained using the two-step treatment. This was due to a lower final bainitic transformation temperature, which induced a higher carbon concentration in the untransformed austenite in the stasis stage; this resulted in untransformed austenite with a higher carbon content existing as RA rather than forming martensite in the subsequent cooling process. In addition, it was determined that the increased stability of RA during the two-step transformation delayed the pop-in point.