A new metamaterial-inspired microwave microfluidic sensor is proposed in this paper. The main part of the device is a microstrip coupled complementary split-ring resonator (CSRR). At resonance, a strong electric field will be established along the sides of CSRR producing a very sensitive area to a change in the nearby dielectric material. A micro-channel is positioned over this area for microfluidic sensing. The liquid sample flowing inside the channel modifies the resonance frequency and peak attenuation of the CSRR resonance. The dielectric properties of the liquid sample can be estimated by establishing an empirical relation between the resonance characteristics and the sample complex permittivity. The designed microfluidic sensor requires a very small amount of sample for testing since the cross-sectional area of the sensing channel is over five orders of magnitude smaller than the square of the wavelength. The proposed microfluidic sensing concept is compatible with lab-on-a-chip platforms owing to its compactness.

The conventional resonant-type microwave microfluidic sensors made of planar resonators suffer from limited sensitivities. This is due to the existence of several distributed capacitors in their structure, where just one of them acts as a sensing element. This article proposes a very high-sensitivity microwave sensor made of a microstrip transmission line loaded with a shunt-connected series LC resonator. A large sensitivity for dielectric loadings is achieved by incorporating just one capacitor in the resonator structure. Applying sample liquids to the microfluidic channel implemented in the capacitive gap area of the sensor modifies the capacitor value. This is translated to a resonance frequency shift from which the liquid sample is characterized. The sensor performance and working principle are described through a circuit model analysis. Finally, a device prototype is fabricated, and experimental measurements using water/ethanol solutions are presented for verification of the sensing principle.

This article presents a microwave sensor using a pair of split-ring resonators (SRRs). The sensor is designed by loading a microstrip transmission line by two identical SRRs on its sides. Differential permittivity sensing is performed by loading the SRRs with dielectric samples. One transmission notch is observed for the identical loads, whereas the non-identical samples produce two split notches. The sensor’s operation principle is described through a circuit model analysis. A prototype of the designed sensor is fabricated and experimentally validated for verifying the differential sensing concept. The developed device can be used to compare or differentially characterize solid dielectric samples improving the robustness to environmental factors producing cross-sensitivity or miscalibration.

A rotation sensor with a wide dynamic range is designed based on tapered U-shaped resonators. The proposed device is composed of a rounded microstrip transmission line that couples to two meandered resonators that are stacked on top of each other. By rotating the upper resonator, the overlapping area between the two resonators is increased causing a stronger coupling that shifts down the resonance frequency of the device. This frequency shift can be read out in the transmission response from which the rotation angle is determined. The operation principle of the sensor is explained in detail by using a circuit model. A sensor prototype is designed for the microwave frequency range and an experiment is presented for validating the proposed sensing approach. This sensing device is well suited for further miniaturization using microelectromechanical systems technology.

A varactor-tunable second-order bandpass frequency-selective surface (FSS) for microwave frequencies is presented in this article. The FSS is composed of three stacked metallic layers. The wire grid in each layer in combination with metallic vias provides the bias for the varactors. This configuration eliminates the need for a dedicated bias network for the varactors, and thus avoids undesirable responses associated with the added bias grid. An equivalent circuit model together with an analytical design method is provided to simplify the design procedure of the FSS. The performance of the proposed structure is experimentally validated in a parallel-plate waveguide setup. Measurements show that by changing the varactor capacitance from 0.12 to 0.38 pF, the center frequency of the filter is tuned from 5.2 to 3.7 GHz with a consistent fractional bandwidth of 9% and with an insertion loss between 3 and 6 dB.