Solar steam generation (SSG) is developed as a promising way for seawater desalination and wastewater purification, bringing new opportunities for solving the shortages of freshwater. Herein, hierarchical columnar RGO bundles with cold evaporation surfaces are designed for high-performance SSG. We find that the evaporation rate can be significantly increased by simply enlarging the dark evaporation area due to the enhanced extraction of energy from the ambient environment. Under one sun irradiation, an extremely high evaporation rate of 4.0 kg m−2 h−1 is obtained by disintegrating the RGO bundles into separated thin scrolls. However, the resulting vapor is not hot enough to be collected by condensation, which has been overlooked previously. To overcome this flaw, an atmospheric water harvester (AWH) is developed by impregnating LiCl salts and carbonized loofah powder (CLP) into a porous hydrogel. The AWH can not only effectively collect the cold vapor but also further improve the water evaporation rate. AWH assisted SSG is used for seawater desalination. The clean water collection rate reaches 2.1 kg m−2 h−1, which is a very competitive performance. And the salinity of the desalinated water is far lower than the standard of potable water set by the World Health Organization (WHO).
21 December 2022 in Journal of Materials Chemistry A
The integration of solar steam generation (SSG) and hydrovoltaic effect provides an ideal strategy for solving the water and energy shortage crisis. However, it is still a challenge to collect freshwater while producing electricity at high efficiency. Here, we report the development of a solar driven freshwater-electricity cogeneration (SFEG) device based on a porous hydrophilic graphene aerogel (HGA). Under 1 sun irradiation, the SFEG device in deionized (DI) water exhibited an evaporation rate of 2.17 kg m−2 h−1 and an output voltage of 0.49 V. Moreover, we reveal that the output voltage and short-circuit current increase first and then decrease as salinity increases. When the salinity is 3.5%, the output voltage reaches 0.87 V with a maximum output power density of 6.84 μW cm−2, while the evaporation rate maintains 2.01 kg m−2 h−1. Both the performances of water evaporation and electricity generation are very competitive compared to the state-of-the-art levels. The outdoor experiment demonstrates that the SFEG device can effectively work under real solar irradiation with good durability, suggesting great potential in practical applications.
Enhancing the fluorescence of perovskite nanocrystals (PNCs) will not only boost the development of perovskite light-emitting devices (LEDs), but also broaden their applications in various photoelectronic areas. However, an effective approach to flexibly enhance different emission colors with high enhancement factors is still desired. In this work, SiO2 photonic crystals (PCs) are designed to couple with the radiative emission of PNCs. Blue, green, and red fluorescent PNCs emitting at 460, 517 and 620 nm are coated onto PCs with SiO2 particle sizes of 200, 230, and 274 nm, respectively. Fluorescence enhancement factors of 22, 12, and 19 are acquired when the excitation power is 0.078 W. Moreover, the enhancement factor noticeably increases with the excitation power. The enhancement factor for blue PNCs is over 250 with an excitation power of 0.09 W. The enhanced fluorescence of PNCs will facilitate the fluorescence signal acquisition with low noise, which is favorable for optical sensing. As a proof of concept, we demonstrate that the luminescence temperature sensing capability of the PNCs on SiO2 PCs is significantly boosted compared to that of the PNCs on glass.