To improve the bending performance of long-span bamboo scrimber beams, a new method of prepressing-cold pressing-hot forming was used to produce steel-reinforced bamboo scrimber composite beams. For steel-RBSC beams, four-point bending experiments were performed to study the failure mode, bending performance, load-displacement relationships, and strain history curves of composite beams. Based on cohesive zone model theory, finite element models of steel-RBSC beams were established and the bonding stress of the adhesive layer in steel-RBSC beams revealed. The results indicated that the failure mode of composite beams was fracture failure of the bamboo scrimber at the bottom between the loading rollers. Steel reinforcement had a significant effect on the strength and stiffness of bamboo scrimber beams. The maximum static stiffness of composite beams was increased by 70.15%, compared with that of bamboo scrimber beams. The load-displacement curves, mechanical properties, and section strains predicted by finite element models were consistent with the test results, verifying that these finite element models were correct. The main influence factors for the peeling of the adhesive layer were normal stress, shear stress, and mixed stress in the areas of pure bending section, bending-shear section, and loading roll area, respectively.
18 May 2022 in Australian Journal of Structural Engineering
Carbon fiber-reinforced polymer (CFRP) laminates can significantly improve the flexural performance of the bamboo scrimber. This study evaluated the effects of three fabrication methods (one-time hot pressing, secondary hot pressing, and secondary cold pressing) on the flexural performance of CFRP-bamboo scrimber composites. Four-point bending experiments and theoretical analysis were conducted to study the failure modes, flexural performance, load-displacement relationships and strain curves over time of CFRP-bamboo scrimber composites. Besides a theoretical model was proposed to describe the flexural stiffness of CFRP-bamboo scrimber composites. The results indicated that the CFRP-bamboo scrimber composite specimens demonstrated four failure modes depending on the treatment methods. Overall, the static flexural modulus of the one-time hot pressed specimens was superior (up to 1.93 times that of the untreated bamboo scrimber specimen), and the static flexural strength of the secondary cold pressing specimens was superior (up to 3.58 times greater than that of the untreated bamboo scrimber specimen), although neither the static flexural modulus nor the static flexural strength of the secondary hot pressing specimens was satisfactory. Finally, it was illustrated that the theoretical models, established to describe the load-displacement, could accurately predict the experimental results.
Creep performance is a crucial factor that must be considered in structural design. This paper aims to investigate the creep failure mode, creep strain, creep compliance, and other creep properties of bamboo scrimber under long-term tension in parallel-to-grain. To establish a general creep life prediction method for the full stress level of the bamboo scrimber, a multi-branch Kelvin–Voigt model, a generalized Maxwell model, and a creep finite element simulation were employed. The results showed that the creep strain curve of bamboo scrimber included the unsteady creep stage and the stable creep stage, but not the accelerated creep stage. When the stress ratio was less than 0.3, the residual strength decreased gradually. Below 70% of the ultimate load capacity, the creep characteristics of the bamboo scrimber were linear viscoelastic, and the creep compliance was generally independent of the load level. The creep finite element model of bamboo scrimber could accurately calculate the creep deformation of specimens. Based on this creep finite element model and creep failure rules, a life prediction model for the full stress level of bamboo scrimber was established, which could accurately predict the creep life. This paper provides theoretical guidance for the creep design of bamboo scrimber in engineering structures.
4 October 2025 in Construction and Building Materials