Stress localization ahead of a slip band blocked by a grain boundary is measured for three different grain boundaries in unalloyed Mg using high-resolution electron backscatter diffraction (HR-EBSD). The results are compared with a theoretical dislocation pile-up model, from which slip system resistance and micro-Hall–Petch coefficients for different grain boundary types are deduced. The results indicate that grain boundary character plays a crucial role in determining micro-Hall–Petch coefficients, which can be used to strengthen classical crystal plasticity constitutive models to make predictions linked to the effect of grain boundary strengthening.

The powder bed fusion–laser beam (PBF-LB) process, a method of additive manufacturing (AM), was used to print duplex stainless steel (DSS) using commercial-grade 2507 powders. While conventionally processed DSS has a two-phase microstructure consisting of 50% austenite and 50% ferrite, the PBF-LB-printed 2507 alloy was nearly 100% ferrite. Optimal processing conditions that minimized porosity were determined to be 290 W laser power and 1000 mm/s scan speed, and grain size, texture, and phases were characterized as a function of laser power and scan speed. Grain size increased with increasing laser power but decreased with increasing scan speed. A texture diminished with increasing scan speed from 1000 mm/s to 1400 mm/s. No austenite phase was detected. Transmission electron microscopy (TEM) and scanning transmission electron microscopy (STEM) characterization revealed nanoscale chromium nitride precipitates in the ferritic matrix (incoherent hexagonal close-packed (HCP) precipitates at grain boundaries and coherent body-centered cubic (BCC) precipitates within the grains) and a high density of tangled dislocations. Tensile tests of as-printed alloys showed a yield strength of 570 MPa, an ultimate tensile strength of 756 MPa, and an elongation to failure of 10%. The tensile properties were analyzed based on the observed microstructure considering grain size, nanoscale precipitates, and the high density of dislocations.

Additive manufacturing (AM) has provided new possibilities for improving the grain boundary properties of metallic components. However, effectively modifying the microstructure, particularly the grain boundary properties, of laser powder bed fusion (L-PBF) components remains a challenge. Post-processing methods have shown some success in adjusting grain boundary angles, but they have limitations when it comes to complex geometries and internal features. In this study, we propose an innovative in situ heat treatment to control the grain boundary properties of L-PBF components. A model is proposed to predict the thermal cycle at a single point, and it is validated through experiments on 2507 super duplex steel and 316L austenitic steel samples. The results demonstrate that, by applying controlled in situ heat treatment, the dynamic recovery processes can be influenced, and thereby the grain boundary properties of the manufactured parts can be controlled. This proposed method improves our understanding of the impact of in situ heat treatment on grain boundary properties and offers potential for designing and fabricating high-performance L-PBF components. The findings from this study lay the groundwork for the further exploration of grain boundary engineering in metallic components using L-PBF. By leveraging in situ heat treatment, future research can open up new avenues in additive manufacturing, facilitating the production of advanced and high-quality metallic components.