: Screw augers are primary grain conveying equipment in the agriculture industry. Quantitative prediction of grain conveyance using screw augers requires better understanding and measurement of bulk particle-particle and particle-rigid-body interactions. Discrete element modeling (DEM) has potential to simulate particle dynamics and flow within a screw auger and thus provide simulation-based guidance for auger design and operating parameters. The objective of this study was to develop a DEM corn model calibration methodology and validation for combine-harvested corn flow in a commercial screw auger. The methodology used a virtual design of experiment (DOE) varying DEM corn parameters and calibration to match grain pile formation expressed in a normalized angle of repose (AOR). DEM corn particle shape was approximated using 1-sphere and clumped spheres (2-sphere, 5-sphere, and 13-sphere) matching the measured physical parameters of equivalent geometrical diameter, 2D axial dimensions, 3D axial dimensions, and detailed CAD-approximated corn dimensions, respectively. For each DEM corn shape approximation, a virtual DOE using Latin square hypercube design with four independent DEM Hertz-Mindlin contact model interaction coefficients was developed. The DEM assembly of particles matching the initial conditions of the AOR test was created in EDEM 2.7. From the quasi-static AOR of corn flow in the AOR tests and EDEM simulations, the mean square error (MSE), a sum of square difference in grain heights in the AOR tests and EDEM simulations, was used as a bulk material dependent response for the calibration process. The DEM 2-sphere corn shape model and the material interaction coefficients showed the minimum MSE (5.31 mm) compared to the 1-sphere, 5-sphere, and 13-sphere models. With the best DEM corn shape model (2-sphere) and DEM model parameters with the minimum MSE, validation of the DEM in predicting corn flow in a commercial screw auger in laboratory tests at two rotational speeds (250 and 450 rpm) was performed and showed good prediction (within 5% relative error) in matching the change in mass flow rate with the change in auger rotational speed. Keywords: Angle of repose, Corn, Discrete element modeling (DEM), Screw grain auger.
While fermentation is usually done at a fixed temperature, in this study, the effect of having a controlled variable temperature was analyzed. A nonlinear system was used to model batch ethanol fermentation, using corn as substrate and the yeast Saccharomyces cerevisiae, at five different fixed and controlled variable temperatures. The lower temperatures presented higher ethanol yields but took a longer time to reach equilibrium. Higher temperatures had higher initial growth rates, but the decay of yeast cells was faster compared to the lower temperatures. However, in a controlled variable temperature model, the temperature decreased with time with the initial value of 40 C. When analyzing a time window of 60 h, the ethanol production increased 20% compared to the batch with the highest temperature; however, the yield was still 12% lower compared to the 20 C batch. When the 24 h’ simulation was analyzed, the controlled model had a higher ethanol concentration compared to both fixed temperature batches.