Cubic boron nitride (cBN) single crystals are synthesized under high temperature and high pressure in the Li-based system. The growth defects on hexagonal and triangular (111) surfaces of cBN single crystals after rapid cooling are discussed systemically for the first time using the atomic force microscope. Some impurity particles, triangle cone hole defects, lamellar-fault structures, and big steps are obvious on the surfaces of cBN single crystals. The formation mechanism of these defects is analyzed briefly at the synthetic process of cBN single crystals, and the growth mechanism of cBN single crystals transform from the two-dimensional growth to dislocation growth mechanism under high temperature and high pressure.
Nano-titanium can be used in the field of anticorrosive coatings due to its excellent corrosion resistance. In this paper, phenolic resin was modified by nano-titanium using a physicochemical method. The nano-titanium-modified phenolic resin was used as a matrix to prepare the anticorrosive coating. The microstructures of the coatings were analyzed by Scanning Electron Microscope (SEM), X-ray spectroscopy (EDS) and Fourier transform infrared spectroscopy (FTIR). Raman and UV spectrum adhesion of the coating was tested by a scratching method. The corrosion behavior was studied by electrochemical workstation and salt spray test. The results showed that the corrosion resistance of pure phenolic resin coating was significantly improved by the nano-titanium-modified phenolic resin. The coating containing 4% titanium nanoparticles exhibited the best corrosion resistance, with the highest impedance and the smallest corrosion current. The coating remained intact after 480 h of salt spray, showing the best salt spray resistance performance.
Nano-titanium has excellent corrosion resistance and can be widely used in the field of corrosion resistant coatings. This paper introduces nano-weight titanium modified phenolic resin coatings and their anti-corrosion properties to explore the principle of nano-titanium modification and the mechanism of anti-corrosion to further develop more advanced corrosion resistant coatings. The article uses scanning electron microscopy, Fourier transform infrared spectroscopy, Raman spectroscopy and UV-Vis spectrophotometer to characterise the morphology and structure of the nano-titanium modified phenolic resin coatings and to determine the corrosion resistance properties of the modified phenolic resin coatings. The results show that the 4% nano-titanium modified phenolic resin coating, nano-titanium powder and phenolic resin will maximize the dispersion and combination, and the structure is good; nano-titanium grafted on phenolic resin, the successful preparation of nano-titanium modified phenolic resin; modified nano-titanium added to improve the coating's ability of UV absorption. The corrosion resistance of the coating is much better than that of the unmodified phenolic resin coating.
16 October 2014 in Journal of Shanghai Jiaotong University (Science)
This paper focuses on analyzing the corrosion mechanism of stone cutting tool surfaces. Rare earth oxide films were prepared on the tool surface using the electrophoretic deposition–sintering method, and their corrosion resistance was investigated. Microstructural and compositional analyses of the surface layer of shot-peened tools and rare earth oxide films were conducted using characterization techniques such as SEM, EBSD, and XRD. The corrosion resistance of the rare earth oxide films was evaluated via an electrochemical workstation. The results indicate that the corrosion morphology on the stone cutting tool surface is pitting corrosion, which is significantly influenced by the friction of the tool coolant. Shot-peening treatment refines the grains in the tool surface layer, promoting the growth of rare earth oxide films. The rare earth oxide film is mainly composed of cerium oxide (CeO2), presenting a continuous and dense structure with slight peeling after sintering. The Group 3 (0.1 mol/L, 3000 V/m, 5 min) rare earth oxide film exhibits the optimal electrochemical behavior and excellent corrosion resistance, with a corrosion potential (Ecorr) of −0.49 V and a corrosion current density (icorr) of 1.445 × 10−7 A/cm2.