Posterior tibial slope (PTS) and sagittal alignment are important factors in the etiology of knee osteoarthritis and knee surgery. Clinically, sagittal alignment, which indicates flexion contracture of the knee, contributes to knee function in weight-bearing (WB) conditions. PTS and sagittal alignment under WB conditions in varus osteoarthritic knees are presumed to affect each other, but their association remains unclear. In this study, we aimed to clarify the association. In total, 140 osteoarthritic varus knees were investigated. Under WB conditions, a three-dimensional (3D) alignment assessment system was applied via biplanar long-leg X-rays, using 3D-to-2D image registration technique. The evaluation parameters were as follows: 1) 3D mechanical flexion angle (3DMFA) in regards to sagittal alignment, 2) passing point in the WB line (PP), and 3) medial and lateral PTS. The medial and lateral PTS showed a positive correlation with 3DMFA and PP, respectively (medial PTS–3DMFA, p = 0.001; medial PTS–PP, p < 0.0001; lateral PTS–3DMFA, p < 0.0001; lateral PTS–PP, p = 0.002). The flexion contracture group with 3DMFA >5° demonstrated greater PTS than non-flexion contracture group (medial PTS, p = 0.006; lateral PTS, p = 0.006). Both medial and lateral PTS were correlated with sagittal alignment under WB conditions and were larger in the flexion contracture group. This finding can explain the function to take the load articular surface parallel to the ground for holding the balance in WB conditions in the sagittal plane for osteoarthritic knees. Moreover, surgeons may be required to decrease the PTS during knee arthroplasty to restore full extension in knees of patients with fixed flexion contracture.

The inclination of the medial compartment of the proximal tibia (MCT) is assumed to be a critical factor for varus alignment in advanced knee osteoarthritis (OA). This study was aimed at investigating; (1) whether the inclination of MCT is aligned parallel to the ground under weight-bearing (WB) conditions; (2) whether this is associated with the change in alignment and the relative position between the bones; and (3) whether the tibia or femur mainly contributes to the changes. We examined 102 knees (84 women, 18 men; mean 75 years). A three-dimensional (3D) assessment system was applied on biplanar whole lower extremity radiographies using 3D-to-2D image registration technique. The evaluation parameters were 1) MCT angle, 2) femorotibial angle (FTA), 3) medial-lateral femoral location to the tibia (M-L femoral location), 4) WB line passing point, and 5) tibial position to WB line (tibial position) and 6) femoral postion to WB line (femoral position). Each parameter was evaluated in non-WB and WB conditions, and the differences (Δ-parameters). MCT angle in the world coordinate system was larger than that in the tibial coordinate system (p < 0.0001). ΔMCT angle was correlated with ΔFTA (p = 0.002) and ΔM-L femoral location (p = 0.004). The tibial position was the more dominant factor for ΔMCT angle (p = 0.001), ΔFTA (p < 0.0001), and ΔWB line passing point (p < 0.0001) . The inclination in MCT was aligned parallel to the ground under WB conditions (tibial parallel phenomenon). The parallel phenomenon was associated with the change of alignment and the relative position between the bones in the coronal plane. These phenomena were produced mainly by the tibia, not the femur. Level IV.