The Baishitou Tunnel of the Dali–Lincang railway project is a weakly cemented surrounding rock tunnel with geological bedding bias. The deformation of the surrounding rock on the side with the greatest stress is nearly 1 m, which seriously affects construction progress and significantly increases construction cost. In order to achieve the goal of safe, efficient, economic, and socially sustainable development in tunnel construction, it is necessary to study the large deformation of weakly cemented surrounding rock in the geological bedding bias tunnel. Engineering technicians first used field measurement methods to monitor the pressure and deformation of surrounding rock and studied the deformation law of surrounding rock pressure and deformation over time. Secondly, numerical simulation methods were used to study the stress distribution law, plastic failure depth, and initial support stress of tunnel-surrounding rock under different support schemes, and they independently designed a yielding anchor bolt with enhanced anchoring, which plays a key role in controlling the deformation of the surrounding rock. The main conclusions are as follows: (1) Through the analysis of the measured pressure data of the initial branch of the section and the displacement monitoring data of the measuring point, it is found that the deformation of the surrounding rock of the weakly cemented tunnel is large and fast. At the same time, the pressure and deformation of the surrounding rock of the tunnel are greatly affected by geological bedding bias. After the excavation of the inverted arch, the pressure and deformation of the surrounding rock at the right arch shoulder of the tunnel are the highest, reaching 0.832 MPa and 0.53 m, which are significantly greater than those on the left arch shoulder. (2) Using the numerical simulation software FLAC3D 5.0 and ANSYS 16.0, a three-dimensional numerical model of the roadway was established to simulate the stress distribution, plastic failure depth, and initial support stress of the tunnel’s surrounding rock under the influence of geological bedding bias. By comparing the support effects of different support schemes, it was concluded that under the support scheme of “I25 arch + yielding anchor bolt”, the surrounding rock failure depth was small, the stress concentration was weak, and the initial support deformation was controllable as a whole. (3) The self-designed yielding anchor bolt has good economic and applicable value, and it has received the expected support effect after field verification. (4) Various special support measures such as advanced grouting anchor rods, casing arches, or temporary cross supports are used to assist in controlling the large deformation of weakly cemented surrounding rock tunnels to a certain extent.

To further enrich the side-filling structure system of goaf-retaining roadways and explore the compression reaction mechanism of the composite in the support environment of underground mine roadways, this paper introduces a double-wall hollow composite pier structure (FPRSC structure) that is composed of the fiber-reinforced polymer (FRP) composite and polyvinyl chloride plastic (PVC) as restraint materials and the infill material featured with a high water-to-powder ratio. A total of 16 circular specimens with a diameter and height of 100 mm were tested to explore the axial performance of the combined support structure. The main control variables in the present research included the water-to-cement ratio of the high-water material (e.g., 2:1, 3:1, and 4:1), the thickness of the FRP pipe (i.e., 6 mm and 3 mm), the inner diameter of the PVC pipe (i.e., 29 mm and 22 mm), as well as the thickness of the PVC pipe (1.5 mm and 5 mm). Test results showed that the high-water material was under triaxial stress due to the double-wall tube binding, and the bearing capacity of the composite was higher than that of the single material. Meanwhile, the FPRSC structure exhibited obvious strain-hardening characteristics when the infill material is under the combined constraints of double-wall hollow tubes. Moreover, the ratio of PVC-c, FRP-A, and high-water material with a water–cement ratio of 3:1 shows the best axial mechanical properties. The new composite pier structure with high toughness and strength has wide application prospects in the field of goaf retention in deep underground mines.