The effect of dust on photovoltaic modules is investigated with respect to concentration and spectral transmittance. Samples were collected in the form of raw dust as well as accumulated dust on exposed sheets of glass at different tilt angles. Spectral transmittance of the samples was determined. Transmittance variation between top, middle and bottom was identified for samples collected at different inclinations, where the worst case was seen at a tilt angle of 30^o with a non-uniformity of 4.4% in comparison with 0.2% for the 90° tilt. The measured data showed a decrease in transmittance at wavelengths <570 nm. Integrating this with measured spectral responses of different technologies demonstrates that wide band-gap thin-film technologies are affected more than, for example crystalline silicon technologies. The worst case is amorphous silicon, where a 33% reduction in photocurrent is predicted for a dust concentration of 4.25 mg/cm². Similarly, crystalline silicon and CIGS technologies are predicted to be less affected, with 28.6% and 28.5% reductions in photocurrent, respectively. The same procedure was repeated with varying Air Mass (AM), tilt angle and dust concentration values to produce a soiling ratio table for different technologies under different AM, tilt angle and dust concentration values. Copyright © 2012 John Wiley & Sons, Ltd.

This work presents a validation of three satellite-based radiation products over an extensive network of 313 pyranometers across Europe, from 2005 to 2015. The products used have been developed by the Satellite Application Facility on Climate Monitoring (CM SAF) and are one geostationary climate dataset (SARAH-JRC), one polar-orbiting climate dataset (CLARA-A2) and one geostationary operational product. Further, the ERA-Interim reanalysis is also included in the comparison. The main objective is to determine the quality level of the daily means of CM SAF datasets, identifying their limitations, as well as analyzing the different factors that can interfere in the adequate validation of the products.

The electrical ageing of photovoltaic modules during extended damp-heat tests at different stress levels is investigated for three types of crystalline silicon photovoltaic modules with different backsheets, encapsulants and cell types. Deploying different stress levels allows determination of an equivalent stress dose function, which is a first step towards a lifetime prediction of devices. The derived humidity dose is used to characterise the degradation of power as well as that of the solar cell's equivalent circuit parameters calculated from measured current–voltage characteristics. An application of this to the samples demonstrates different modes in the degradation and thus enables better understanding of the module's underlying ageing mechanisms. The analysis of changes in the solar cell equivalent circuit parameters identified the primary contributors to the power degradation and distinguished the potential ageing mechanism for each types of module investigated in this paper. © 2016 The Authors. Progress in Photovoltaics: Research and Applications published by John Wiley & Sons Ltd. © 2016 The Authors. Progress in Photovoltaics: Research and Applications published by John Wiley & Sons Ltd.