Mayuree P. Reilly

Mayuree P. Reilly


Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 February 2024 in Materials
Verified
Journal Article
Open access
PDF file
KPKattaliya Petchnui
Kattaliya Petchnui
TUTeerayut Uwanno
Teerayut Uwanno
MRMayuree P. Reilly
Mayuree P. Reilly
CPChinathun Pinming
Chinathun Pinming
ATAlongkot Treetong
Alongkot Treetong
Winadda WongwiriyapanWinadda Wongwiriyapan
Winadda Wongwiriyapan
Triboelectric nanogenerators (TENGs) have gained significant attention as promising energy-harvesting devices that convert mechanical energy into electrical energy through charge separation induced by friction and electrostatic induction. In this study, we explore the utilization of biowaste shrimp shell-extracted chitin nanofiber (ChNF) as a viable eco-friendly material for TENG applications. Composite materials were prepared by incorporating ChNF into natural rubber (NRL) at loading levels of 0.1 and 0.2 wt% (NRL/ChNF) to form the TENG triboelectric layer. ChNFs with a uniform width of approximately 10–20 nm were successfully extracted from the shrimp shells through a simple mechanical procedure. The NRL/ChNF composites exhibited enhanced mechanical properties, as evidenced by a higher Young’s modulus (3.4 GPa) compared to pure NRL. Additionally, the NRL/ChNF composites demonstrated an increased dielectric constant of 3.3 at 0.1 MHz. Moreover, the surface potential difference of NRL increased from 0.182 V to 1.987 V in the NRL/ChNF composite. When employed as the triboelectric layer in TENG, the NRL/ChNF composites exhibited significant improvement in their output voltage, with it reaching 106.04 ± 2.3 V. This enhancement can be attributed to the increased dielectric constant of NRL/ChNF, leading to enhanced charge exchange and charge density. This study presents a straightforward and environmentally friendly technique for preparing sustainable natural materials suitable for energy-harvesting devices.

10 August 2023 in Coatings
Verified
Journal Article
Open access
PDF file
KKKanisorn Klangvijit
Kanisorn Klangvijit
Winadda WongwiriyapanWinadda Wongwiriyapan
Winadda Wongwiriyapan
TUTeerayut Uwanno
Teerayut Uwanno
MOMichiko Obata
Michiko Obata
MFMasatsugu Fujishige
Masatsugu Fujishige
MRMayuree P. Reilly
Mayuree P. Reilly
Manganese oxide has been studied as a promising supercapacitor electrode due to its high theoretical capacitance, low cost, and environmental friendliness. Supercapacitor performance such as specific capacitance, resistance, and cycle life greatly depends on the morphology and crystal structure of manganese oxide. In this study, a Mn3O4 hybrid structure was successfully synthesized using electrodeposition and successive ionic layer adsorption and reaction (SILAR) techniques which are simple, cost-effective, and low-temperature wet chemical processes. It was found that Mn3O4 morphology is different depending on manganese precursors and synthesis techniques. Sea-grape-like and bird nest-like morphologies were obtained via the electrodeposition technique, while flower-like and nanoparticle morphologies were formed via the SILAR technique using manganese acetate and manganese sulfate as precursors, respectively. The hybrid structure of the nanoparticle-decorated bird nest-like heterostructure was prepared using manganese sulfate electrodeposition and subsequent SILAR deposition of manganese acetate. X-ray photoelectron spectroscopy confirmed the Mn3O4 formation. Electrochemical properties of manganese oxide hybrid structure were systematically studied with cyclic voltammetry and galvanostatic charge–discharge, showing the highest areal capacitance of 390 mF cm−2 at 0.1 mA cm−2 with series and charge transfer resistances down to 4.55 and 4.91 Ω in 1 M sodium sulfate electrolyte.