Pneumatic artificial muscles are soft actuators which resemble human skeletal muscles. They are attractive for many applications where safety, human interaction or biomimetic behavior is required. However, its use is not yet widespread because of the difficulties of working with them, such as high nonlinearities, difficult to model and control accurately. This work proposes a simple method for controlling the pneumatic muscle, which is using a PID controller tuned with a simulated annealing optimization algorithm.
There is a widely accepted consensus that component manufacturing precision is directly correlated with improved functional performance. However, this increase in precision comes at the expense of higher manufacturing costs, resulting in a trade-off between quality and affordability. In light of this opposing behavior, low-cost products typically exhibit lower quality, whereas high-quality products tend to be more expensive. This study introduces a novel approach for optimizing the dimensional tolerances of mechanical assembly components, taking into account both their manufacturing requirements and the associated costs of non-quality. Furthermore, the method considers the functional constraints imposed by interrelated tolerance chains within the product. Instead of relying on an exact mathematical solution, the proposed solution employs a heuristic approach through a simple and flexible algorithm. This enables practical implementation, as different cost-tolerance functions can be selected based on specific requirements. To provide a comprehensive evaluation of the proposed method, a concise review of the relevant literature in the field was conducted, allowing a comparison with other state-of-the-art approaches.
1 November 2002 in Journal of the Brazilian Society of Mechanical Sciences
This paper presents a new type of magnetic bearing with active control only in axial direction. The bearing uses two pairs of permanent magnets working in attraction mode to restrict the radial motion and a control system composed of two electromagnets, a gap sensor and a controller to keep the axis in a fixed axial position. The principle, the dynamic model for axial motion and the control system for this bearing are presented. Finally, by experiments conducted in a prototype, the effectiveness of the presented concept is shown
Hybrid bearings that combine passive magnetic suspension with minimal mechanical contact are an attractive alternative to purely mechanical or actively controlled magnetic bearings, especially in compact, low-power applications. This work presents the concept and design methodology of a Magnetic-Passive and Sliding (MPS) bearing, in which two stages of permanent magnets operating in attraction mode provide radial stiffness, while a pivot-type thrust bearing maintains axial positioning. Using axisymmetric finite element analyses, we investigate how magnet material, diameter combination, and height influence radial stiffness, and we identify simple design rules that suppress dead-zone regions and maximize stiffness for a given magnet volume. Complementary tribological considerations are used to compare flat, conical, and spherical pivots, leading to the choice of a spherical tip as a compromise between wear and friction torque. A practical air-gap tuning strategy is then proposed to balance the axial magnetic forces and any static load, keeping the resultant axial force on the pivots below sub-newton levels. The design guidelines are validated on a prototype MPS bearing operating at 9,000 rpm in a deliberately severe accelerated wear test: dry contact between a steel spherical pivot and a PVC antagonist over 120 hours. Despite the unfavorable material pairing, only modest pivot wear and very low friction torque were observed, confirming the feasibility of the MPS concept as a simple, energy-independent bearing solution for applications with dominant radial loads and limited maintenance access.