Pollutants produced by engines are a significant source of environmental pollution, so the study of engine emissions is very important. In this study, with CONVERGE software, a diesel engine model of the engine was produced. To better obtain the characteristic results of the engine, this was coupled with an improved chemical kinetics mechanism. Then, the results of this model were verified experimentally. Additionally, the effects of four different EGR rates on the combustion, performance, and emissions of a dual-fuel diesel engine were investigated by the verified model under different (50 %, 75 %, and 100 %) load conditions. Lastly, the brake specific fuel consumption, NOx emission, and HC emission were optimized by the response surface methodology (RSM). The results show that the pressure, temperature, and NOx emission in the engine's cylinder can all be reduced by raising the EGR at three different loads. Besides, the optimization results show that the engine achieves the best operating conditions at 100 % load, hydrogen fraction of 6.92 %, and EGR rate of 7.68 %.
In this paper, a computational fluid dynamics (CFD) model was established and verified on the basis of experimental results, and then the effect of hydrogenation addition on combustion and emission characteristics of a diesel–hydrogen dual-fuel engine fueled with hydrogenation addition (0%, 5%, and 10%) under different hydrogenation energy shares (HESs) and compression ratios (CRs) were investigated using CONVERGE3.0 software. And, this work assumed that the hydrogen and air were premixed uniformly. The correctness of the simulation model was verified by experimental data. The values of HES are in the range of 0%, 5%, 10%, and 15%. And, the values of CR are in the range of 14, 16, 18, and 20. The results of this study showed that the addition of hydrogen to diesel fuel has a significant effect on the combustion characteristics and the emission characteristics of diesel engines. When the HES was 15%, the in-cylinder pressure increased by 10.54%. The in-cylinder temperature increased by 15.11%. When the CR was 20, the in-cylinder pressure and the in-cylinder temperature increased by 66.10% and 13.09%, respectively. In all cases, HC, CO, CO2, and soot emissions decreased as the HES increased. But, NOx emission increased.