The excellent performance and radiation-hardness potential of carbon nanotube (CNT) field effect transistors (CNTFETs) have attracted wide attention. However, top-gate structure CNTFETs, which are often used to make high-performance devices, have not been studied enough. In this paper, the total ionizing dose (TID) effect of the top-gate structure CNTFETs and the influence of the substrate on top-gate during irradiation are studied. The parameter degradation caused by the irradiation- and radiation-damage mechanisms of the top-gate P-type CNTFET were obtained by performing a Co-60 γ-ray irradiation test. The results indicate that the transfer curves of the top-gate P-type CNTFETs shift negatively, the threshold voltage and the transconductance decrease when TID increases, and the subthreshold swing decreases first and then increases with the increase in TID. The back-gate transistor is constructed by using the substrate as a back-gate, and the influence of back-gate bias on the characteristics of the top-gate transistor is tested. We also test the influence of TID irradiation on the characteristics of back-gate transistors, and reveal the effect of trapped charge introduced by radiation on the characteristics of top-gate transistors. In addition, the CNTFETs that we used have obvious hysteresis characteristics. After irradiation, the radiation-induced trapped charges generated in oxide and the OH groups generated by ionization of the CNT adsorbates aggravate the hysteresis characteristics of CNTFET, and the hysteresis window increases with the increase in TID.
The effects of proton irradiation on CMOS Single-Photon Avalanche Diodes (SPADs) are investigated in this article. The I–V characteristics, dark count rate (DCR), and photon detection probability (PDP) of the CMOS SPADs were measured under 30 MeV and 52 MeV proton irradiations. Two types of SPAD, with and without shallow trench isolation (STI), were designed. According to the experimental results, the leakage current, breakdown voltage, and PDP did not change after irradiation at a DDD of 2.82 × 108 MeV/g, but the DCR increased significantly at five different higher voltages. The DCR increased by 506 cps at an excess voltage of 2 V and 10,846 cps at 10 V after 30 MeV proton irradiation. A γ irradiation was conducted with a TID of 10 krad (Si). The DCR after the γ irradiation increased from 256 cps to 336 cps at an excess voltage of 10 V. The comparison of the DCR after proton and γ-ray irradiation with two structures of SPAD indicates that the major increase in the DCR was due to the depletion region defects caused by proton displacement damage rather than the Si-SiO2 interface trap generated by ionization.
1 February 2004 in Radiation Effects and Defects in Solids
Modifications to a universal electronic stopping power equation for nonrelativistic heavy ions in solids have been made. Some calculations of electronic stopping power for protons are performed using the new equation for a variety of targets with different atomic numbers. The results are close to that of the TRIM program.
The space radiation environment has a radiation effect on electronic devices, especially the total ionizing dose effect, which seriously affects the service life of spacecraft on-orbit electronic devices and electronic equipment. Therefore, it is particularly important to enhance the radiation resistance of electronic devices. At present, many scientific research institutions still use the areal density equivalent aluminum method to calculate the shielding dose. This paper sets five common metal materials in aerospace through the GEANT4 Monte-Carlo simulation tool MULASSIS, individually calculating the absorption dose caused by single-energy electrons and protons in the silicon detector after shielding of five different materials, which have the same areal density of 0.8097 g/cm2. By comparing the above data, it was found that depending on the particle energy, the areal density aluminum equivalent method would overestimate or underestimate the absorbed dose in the shielded silicon detector, especially for the ionization total dose shielding effect of low-energy electrons. The areal density aluminum equivalent method will greatly overestimate the shielding dose, so this difference needs to be taken into account when evaluating the ionizing dose of the electronics on a spacecraft to make the assessment more accurate.