The production of printable graphene flakes is not easy to scale up when produced by ultrasonication and purified by centrifugation. In this work, natural graphite flakes were exfoliated by wet ball milling in water supported by the addition of sodium deoxycholate as a surfactant and the dispersion was formulated for inkjet printing. By subsequent dilution and filtration of the milling paste, more than 45 l of a stable dispersion of nano-graphite particles in one batch process was obtained. The dispersion was characterized by thermogravimetric analysis and UV–vis spectroscopy to determine concentration, and experiments to measure long-term stability were conducted. The nano-graphite particles were analyzed by optical microscopy, scanning electron microscopy and Raman spectroscopy, revealing 300–400 nm sized particles. The dispersion was formulated into an inkjet ink and tested as interfacial hole transport layer between the anode and the photo-active bulk-heterojunction layer of an organic solar cell with inverted structure. The nano-graphite flakes are inkjet printable and conductive and therefore show potential as a low-cost alternative to polymer poly(3,4-ethylenedioxythiophene) polystyrene sulfonate.
This work demonstrates the green production of a graphene ink for inkjet printing and its use as a hole transport layer (HTL) in an organic solar cell. Graphene as an HTL improves the selective hole extraction at the anode and prevents charge recombination at the electronic interface and metal diffusion into the photoactive layer. Graphite was exfoliated in water, concentrated by iterative centrifugation, and characterized by Raman. The concentrated graphene ink was incorporated into inverted organic solar cells by inkjet printing on the active polymer in an ambient atmosphere. Argon plasma was used to enhance wetting of the polymer with the graphene ink during printing. The argon plasma treatment of the active polymer P3HT:PCBM was investigated by XPS, AFM and contact angle measurements. Efficiency and lifetime studies undertaken show that the device with graphene as HTL is fully functional and has good potential for an inkjet printable and flexible alternative to PEDOT:PSS.