This paper focuses on the operating behavior of journal bearings for industrial machinery application during run-ups. For this purpose, a numerical simulation code that is based on a two-dimensional extended and generalized Reynolds equation and a full three-dimensional energy equation, was advanced by a theoretical model considering the effects of mixed friction and warming of journal components during start-up. The mixed friction routine contained the elastic half-spaces model proposed by Boussinesq, which considers the influence of rough surfaces by implementing flow factors and calculates additional stiffness and dissipation in areas with solid interactions. Furthermore, a transient term was added in the energy equation to consider the thermal inertia of journal, and bearing to ensure a realistic heating during run-ups. Results of the prediction were compared to experimental data taken from a special test rig built up for validation procedures. Besides the conventional sensors for temperature, oil flow, and relative motion between shaft and stator, a contact voltage measurement was installed to determine the intensity of mixed friction. The evaluation of experimental data by Stribeck curves, based on a shaft torsion measurement, indicated a significant influence of run-up time on frictional moment. The friction coefficient of the rotor bearing system was strongly influenced by the run-up time. A short run-up time reduced the frictional coefficient in the mixed lubrication regime while the opposite behavior was observed in the hydrodynamic lubrication regime. The numerical code predicted these tendencies in good agreement with experimental data, however, only if the transient energy model was applied.

Linearized dynamic bearing parameters and models are of essential interest for rotordynamic analyses in machine design. This paper experimentally studies the impact of pad preload and pivot offset on the frequency-dependent characteristics of dynamic stiffness (K) and damping coefficients (C) of a KC-model for tilting-pad journal bearings. For this purpose, two four-pad test bearing configurations (preload $m=0.17$, pivot offset 0.5 and preload $m=0.47$, pivot offset 0.6) that differ highly with respect to the pad design parameters are investigated. Contributing effects on the results due to geometric differences are excluded as far as possible, as only one aligning ring and one pivot support design is used. The tests are conducted on a high-performance test rig for surface speeds up to 140 m/s and excitation frequencies of 500 Hz. Significant deviations between the two bearings are identified that generally match theoretically predicted differences and, therefore, contribute to the validation of dynamic bearing modeling.

Philipp Zemella\* (zemella@itr.tu-clausthal.de; Phone: 0049-5323-723690) Thomas Hagemann\* (hagemann@itr.tu-clausthal.de; Phone: 0049-5323-722469) Pfau, Bastian\*\* (bastian.pfau@voith.com, Phone: 0049-7951-32795) Hubert Schwarze\* (schwarze@itr.tu-clausthal.de; Phone: 0049-5323-722465) \*Institute of Tribology and Energy Conversion Machinery, Clausthal University of