In this work, we report the experimental results obtained on a set of ∼90 nm thick FeRh epitaxial films deposited on MgO (001), MgO (111), and Al2O3 (0001) single crystal substrates. The magnetic characterization was achieved by measuring magnetization curves and ferromagnetic resonance as a function of temperature and orientation of the films with respect to the applied magnetic field. We discuss our results by comparing the characteristics of the antiferromagnetic-ferromagnetic transition among FeRh films of the same thickness but exposed to different post-growth annealings and deposited on substrates of different crystalline orientations. We have found that there is a correlation between the strain present in the films and their magnetic behavior, observing that a change in the in-plane stress from compressive to tensile tends to shift the magnetic transition by more than 60 K. The interplay between magnetic and elastic properties was further analyzed by ferromagnetic resonance, and we have found that the magnetoelastic component of the anisotropy varies from out-of-plane to in-plane, depending on the substrate. These findings could be of great importance if a precise tuning of the magnetic transition temperature or the magnetic anisotropy is needed for a specific application.
High energy x-ray diffraction measurements of pure amorphous Ge were made and its radial distribution function (RDF) was determined at high resolution, revealing new information on the atomic structure of amorphous semiconductors. Fine structure in the second peak in the RDF provides evidence that a fraction of third neighbors are closer than some second neighbors; taking this into account leads to a narrow distribution of tetrahedral bond angles, . A small peak which appears near 5 Å upon thermal annealing shows that some ordering in the dihedral bond-angle distribution takes place during structural relaxation. Extended range order is detected (in both -Ge and -Si) which persists to beyond 20 Å, and both the periodicity and its decay length increase upon thermal annealing. Previously, the effect of structural relaxation was only detected at intermediate range, involving reduced tetrahedral bond-angle distortions. These results enhance our understanding of the atomic order in continuous random networks and place significantly more stringent requirements on computer models intending to describe these networks, or their alternatives which attempt to describe the structure in terms of an arrangement of paracrystals.
The optical design for the high-energy x-ray diffraction and scattering beamline of the Brockhouse sector at the Canadian Light Source is described. The design is based on a single side-bounce silicon focusing monochromator that steers the central part of a high-field permanent magnet wiggler beam into the experimental station. Two different configurations are proposed: a higher energy resolution with vertical focusing and a lower energy resolution with horizontal and vertical focusing. The monochromator will have the possibility of mounting three crystals: one crystal optimized for 35 keV that focuses in the horizontal and vertical directions using reflection (1,1,1) and two other crystals both covering the energies above 40 keV: one with only vertical focusing and another one with horizontal and vertical focusing. The geometry of the last two monochromator crystals was optimized to use reflections (4,2,2) and (5,3,3) to cover the broad energy range from 40 to 95 keV.
Hydrogen is a promising green fuel carrier that can replace fossil fuels; however, its storage is still a challenge. Carbon-based materials with metal catalysts have recently been the focus of research for solid-state hydrogen storage due to their efficacy and low cost. Here, we report on the exfoliation of expanded graphite (EG) through high shear mixing and probe tip sonication methods to form graphene-based nanomaterial ShEG and sEG, respectively. The exfoliation processes were optimized based on electrochemical capacitance measurements. The exfoliated EG was further functionalized with palladium nanoparticles (Pd-NP) for solid-state hydrogen storage. The prepared graphene-based nanomaterials (ShEG and sEG) and the nanocomposites (Pd-ShEG and Pd-sEG) were characterized with various traditional techniques (e.g., SEM, TEM, EDX, XPS, Raman, XRD) and the advanced high-resolution pair distribution function (HRPDF) analysis. Electrochemical hydrogen uptake and release (QH) were measured, showing that the sEG decorated with Pd-NP (Pd-sEG, 31.05 mC cm−2) and ShEG with Pd-NP (Pd-ShEG, 24.54 mC cm−2) had a notable improvement over Pd-NP (9.87 mC cm−2) and the composite of Pd-EG (14.7 mC cm−2). QH showed a strong linear relationship with an effective surface area to volume ratio, indicating nanoparticle size as a determining factor for hydrogen uptake and release. This work is a promising step toward the design of the high-performance solid-state hydrogen storage devices through mechanical exfoliation of the substrate EG to control nanoparticle size and dispersion.
The design, performance, and capabilities of the High Energy beamline at the Brockhouse Sector of the Canadian Light Source are described. The beamline uses a single bent silicon wafer as a side-bounce Laue monochromator, using the (111), (422), or (533) hkl reflections to access energies ranging from 25 to 90 keV. The cryogenically cooled crystal serves as the only optical element in the beamline providing a simple, convenient, and reliable configuration. The bending provides a vertical focus as small as 20 µm. The flux ranges from 1 × 1010 to 1 × 1013 photons s−1, depending on the energy, with typical pre-monochromator slit settings. A large translation table in the hutch moves to follow the beam as the energy is changed. Data are collected using large area detectors. Common uses include rapid collection of powder diffraction data, penetration of thick samples and devices, high pressure diffraction, and pair distribution function measurements.