The effect of the channel interface of top-gate InGaZnO (IGZO) thin film transistors (TFTs) on the electrical properties caused by exposure to various wet chemicals such as deionized water, photoresist (PR), and strippers during the photolithography process was studied. Contrary to the good electrical characteristics of TFTs including a protective layer (PL) to avoid interface damage by wet chemical processes, TFTs without PL showed a conductive behavior with a negative threshold voltage shift, in which the ratio of Ga and Zn on the IGZO top surface reduced due to exposure to a stripper. In addition, the wet process in photolithography increased oxygen vacancy and oxygen impurity on the IGZO surface. The photo-patterning process increased donor-like defects in IGZO due to organic contamination on the IGZO surface by PR, making the TFT characteristics more conductive. The introduction of ozone (O3) annealing after photo-patterning and stripping of IGZO reduced the increased defect states on the surface of IGZO due to the wet process and effectively eliminated organic contamination by PR. In particular, by controlling surface oxygens on top of the IGZO surface excessively generated with O3 annealing using UV irradiation of 185 and 254 nm, IGZO TFTs with excellent current–voltage characteristics and reliability could be realized comparable to IGZO TFTs containing PL.
Inductively coupled plasma–reactive etching (ICP-RIE) of InGaZnO (IGZO) thin films was studied with variations in gas mixtures of hydrochloride (HCl) and argon (Ar). The dry etching characteristics of the IGZO films were investigated according to radiofrequency bias power, gas mixing ratio, and chamber pressure. The IGZO film showed an excellent etch rate of 83.2 nm/min from an optimized etching condition such as a plasma power of 100 W, process pressure of 3 mTorr, and HCl ratio of 75% (HCl:Ar at 30 sccm:10 sccm). In addition, this ICP-RIE etching condition with a high HCl composition ratio at a moderate RIE power of 100 W showed a low etched pattern skew and low photoresist damage on the IGZO patterns. It also provided excellent surface morphology of the SiO2 film underneath after the entire dry etching of the IGZO layer. The IGZO thin film as an active layer was successfully patterned under the ICP-RIE dry etching under the HCl-Ar gas mixture, affording an excellent electrical characteristic in the resultant top-gate IGZO thin-film transistor.