Knowledge of the response of growth parameters of almond (Badam) trees to different water supply conditions is important for Badam production. To identify growth parameters that are sensitive to water deficit in almond trees, field experiments were conducted during a median water year to monitor the major growth characteristics of almond trees under different irrigation conditions in Shache County, Xinjiang, China. A field (in-situ) monitoring system was also constructed using various sensors for the continuous and non-destructive monitoring of the growth parameters, such as soil water in the root zone, canopy temperature depression, trunk diameter, and fruit diameter of almond trees. The results confirmed the reliability of the monitoring system. Both canopy temperature depression and the diameter shrinkage of the trunk and fruit were significantly negatively correlated (r values ranging from −0.996 to −0.823) with the irrigation water quantity. This correlation was observed from the young fruit stage to the maturation stage of almond trees, under irrigation conditions representing 50–100% of crop evapotranspiration (ETc). These parameters were sensitive (|r| ≥ 0.778) to the water deficit status of almond trees from 14:00 to 18:00 in sunny weather. These results can provide both technical and theoretical support for real-time non-destructive assessment of the water deficit status of almond trees.
To enhance the mechanical properties and surface quality of PET composite aluminum foil fabricated by vacuum evaporation, an L9 (34) orthogonal experiment was performed to explore the influences of cooling roll temperature, evaporation boat voltage, tension roll force, and bias current on tensile strength, elongation, and surface morphology. Evaporation boat voltage had the most significant effect on tensile strength, whereas bias current mainly controlled elongation. The optimal parameters were identified as −30 °C, 10.5 V, 55 N, and 35 mA. Under these conditions, sample CAF-10 reached a tensile strength of 262.8 MPa and an elongation of 58.28% with a defect-free surface. A strong negative correlation between tensile strength and elongation was observed. Better interfacial bonding increased strength but reduced elongation, presenting an obvious trade-off. Overly high temperature or tension led to material defects and degraded the composite strength. These results validate the feasibility of orthogonal optimization and offer technical support for the industrial manufacturing of high-performance PET composite aluminum foil.
To improve the efficiency and quality of polyethylene terephthalate (PET) recycling, the air separation recovery of PET and biaxially oriented polypropylene (BOPP) materials in broken plastic beverage bottles was explored and analyzed in this study. A gas–solid two-phase flow model was established to simulate the movement of flaky mixtures with different textures in the wind field. Analysis results show that wind velocity at the air outlet (A), initial material falling speed (B), angle between wind velocity at the outlet (C) and the horizontal direction, and material feed rate (D) are the key parameters that affected the separation. On the basis of the simulation results, an orthogonal experiment with four factors and three levels was designed, and range analysis and ANOVA were performed on the test results, which present the result of the influencing degree of each factor on the separation rate as follows: A > B > C > D. The fitting analysis of 3D scattered-point surfaces, the interaction between A and B exerts the greatest influence on the separation rate in the six groups of interaction experiments. The best separation parameters are acquired for the experiment, and the mass percentage of recycled PET is 99.96%, which achieve recycling requirements. Keywords: EDEM–Fluent coupling; Air separation; Orthogonal experiment; PET/BOPP mixture