Pavol Smoleň

Mr. Pavol Smoleň

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 August 2023 in Energies
Verified
Journal Article
Open access
PDF file
Karol KyslanKarol Kyslan
Karol Kyslan
PSPavol Smoleň
Pavol Smoleň
VŠViktor Šlapák
Viktor Šlapák
Frantisek DurovskyFrantisek Durovsky
Frantisek Durovsky
Position control algorithms can be classified into two groups: point-to-point control and continuous path control. For point-to-point control implemented in programmable logic controllers, the speed setpoint is mostly the only setpoint transmitted to the industrial converter. Incorrect settings of the position controller in PLC may lead to position overshoot or oscillations, which are unacceptable in position control applications. The speed control structure in the industrial converter usually has a fixed structure which does not allow the implementation of advanced speed controller. Moreover, standard library blocks for position control encounter difficulties in diagnostics and tuning. To address these limitations, this paper proposes a novel solution for position control that achieves time-optimal speed trajectory during acceleration and enhanced capabilities during deceleration. The proposed controller was verified by simulations of positioning of zinc ingot feeder unit drive and compared with a standard P-controller. Experimental results confirmed the performance of the proposed controller with the industrial application of a feeder unit.

1 January 2024 in Power Electronics and Drives
Verified
Journal Article
Open access
PDF file
VŠViktor Šlapák
Viktor Šlapák
Frantisek DurovskyFrantisek Durovsky
Frantisek Durovsky
Karol KyslanKarol Kyslan
Karol Kyslan
PSPavol Smoleň
Pavol Smoleň
Rotary shears are common part of the material processing lines (MPL). During the operation, these shears are loaded with impact cutting torque, which takes only short time but reaches values compared to motor-rated torque. Therefore, it is a technical challenge to ensure the speed stability during the cut. The presented paper deals with the analysis of the rotary shears’ operation and material cutting process from the control point of view and presents a cutting torque compensation possibility. Three types of speed controllers without and with cutting torque compensation are compared.

25 September 2023
Verified
Conference Paper
Closed access
PSPavol Smoleň
Pavol Smoleň
Frantisek DurovskyFrantisek Durovsky
Frantisek Durovsky
The article describes a physical model of a material processing line intended for education of complex mechatronic systems control. The mechanical part of model consists of an uncoiler, coiler, bridle, tension roll and horizontal web accumulator. The control of model is done by a PLC-based technological controller and the motors are powered by frequency converters. The model allows set up different configurations of the processing line. The article is supplemented with a simple example of processing line configuration with corresponding control structure and time responses of important line variables.