The objective of this study was to establish a suitable chemical process to recover magnesium compounds from Dead Sea water using a selective precipitation process. The recovered magnesium hydroxide (Mg(OH)2) and magnesium chloride (MgCl2) are applicable for wastewater treatment processes since they can effectively remove total suspended solids (TSS) and chemical oxygen demand (COD). Magnesium salts recovered from Dead Sea water were compared with cationic polyacrylamide (PAM) and inorganic salts, including aluminum sulfate Al2(SO4)3, ferric chloride (FeCl3), and ferrous sulfate (Fe2SO4) to investigate the removal efficiency of TSS and COD from wastewater using a chemical precipitation method by using coagulation and flocculation process. Results show that Mg(OH)2 yielded the highest TSS and COD removal efficiencies of 59 and 57%, respectively, with a wastewater pH of 11.5. MgCl2 yielded lower removal efficiencies of 46 and 44%, respectively; at pH 10.5, lower magnesium concentration doses were needed. The most effective chemical precipitation method for removal involved cationic PAM coagulants, resulting in an 86% reduction in TSS and a 65% reduction in COD. Combining commercial Fe2SO4 and MgCL2 recovered from Dead Sea water reduced up to 90 and 73% of TSS and COD, respectively.
Per- and polyfluoroalkyl substances (PFAS) are arguably the most common water contaminants in the world today. While several research experiments have been done to understand and remove PFAS from the environment, there is still a lot of unknown. Little has been known about the use of Machine learning (ML) to understand PFAS. This work hence reviews some leading ML approaches and applications in PFAS studies in the distribution, transport, removal, and occurrence predictions of PFAS. Several evaluation matrices were examined and used to perform this function. There are still a lot of areas whereby ML can be used to improve our PFAS knowledge base, some of these were briefly stated in this review.
During the last decade, the demand for lithium has been growing exponentially with its widespread uses in manufacturing, especially with the worldwide deployment of electric vehicles. Thus, lithium is considered integral to the U.S. economy, technological advancement, and the pursuit of sustainable and clean energy solutions. The produced water is known to be rich in several minerals and valuable elements, such as potassium and magnesium, and a trace amount of precious elements including lithium. However, the existence of metals in the produced water is one of the challenges to extract lithium, especially magnesium which is located in diagonal positions within the periodic table that exhibit similarities. The produced water was first purified, resulting in the complete removal of magnesium, and then lithium was precipitated by phosphate. The effects of operating conditions on the Li3PO4 precipitation behaviors were evaluated. The effect of different precipitating reagents was evaluated on the percentage of lithium extracted, Na3PO4 (TSP) was found to be a promising Li precipitating reagent. The highest percentage of lithium extracted was reached when the Li concentration of produced water was enriched and increased up to 350 mg/l, then Li removal was 53% at 7 grams of TSP and 200 rpm for 2 hours. The results indicated that temperature is a more important factor than stirring speed. The novelty of the current work is not only by the results obtained that may create additional financial benefits to oil-producing areas but on that the sustainable disposal of produced water may encourage the recycling and reuse practice, ultimately reducing the use of freshwater for hydraulic fracturing.