Qiang Wang

Qiang Wang


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 September 2023 in Lubricants
Verified
Journal Article
Open access
PDF file
HWHanqiang Wu
Hanqiang Wu
XYXimin Ye
Ximin Ye
ZCZhuo Chen
Zhuo Chen
SZShibo Zhang
Shibo Zhang
JZJiang Zeng
Jiang Zeng
YWYongbo Wu
Yongbo Wu
To reduce wheel loading caused by chip adhesion in the grinding of titanium alloys, a new method named ultrasonic-assisted plasma oxidation modification grinding is suggested. The processing principle was introduced in this research, and based on that, the experimental apparatus was established. Then, the surface and cross-sectional morphologies of a workpiece with an oxide layer were characterized, followed by the detection of its microhardness and surface composition. On this basis, in the absence and presence of the oxide layer, the dynamic changes in wheel loading on the grinding wheel surface and the evolution behavior of chip adhesion on the grains were both investigated after gradually increasing the grinding passes. Finally, the effects of wheel loading on the ground surface morphologies were analyzed. The results showed that the oxide layer with low microhardness was mainly composed of TiO2 and Al2O3. Moreover, with an increase in grinding passes, the overall occupied area of chip adhesion on the grinding wheel surface increased proportionally in the absence of the oxide layer, which finally caused severe wheel loading. Conversely, yet at almost the same rate, the overall occupied area of chip adhesion increased after remaining comparatively unchanged in a short range of grinding passes in the presence of the oxide layer, which effectively inhibited the wheel loading. Compared with the ground surface obtained without an oxide layer, the generation of plastic-stacking was significantly restrained with the assistance of the oxide layer, thereby improving the ground surface quality.

8 December 2022 in Machines
Verified
Journal Article
Open access
PDF file
LZLongfei Zhao
Longfei Zhao
SLSisi Li
Sisi Li
XZXianglei Zhang
Xianglei Zhang
HZHongming Zhou
Hongming Zhou
QWQiang Wang
Qiang Wang
In the grinding process, the friction energy generated by grains and the workpiece in the grinding zone will affect the service life of the grinding wheel. Ultrasonic-vibration-assisted grinding (UVAG) can reduce the friction force and reduce the generation of friction energy during grinding. In this work, the wear mechanism of grinding wheels in UVAG is discussed in detail from the perspective of the grain grinding trajectory and tribology. The results show that UVAG has a smaller friction force than conventional grinding (CG). Furthermore, when the initial included angles of grains are 90° and 150°, the friction energy of a single grinding surface in UVAG is reduced by 24% and 37% compared with that of CG, respectively. In UVAG, the grains are prone to microfractures, and the self-sharpening ability of the grinding wheel is enhanced, which can obtain a lower grinding force and better grinding surface quality.

25 January 2025 in Advances in Manufacturing
Verified
Journal Article
Closed access
PDF file
YLYan-Jun Lu
Yan-Jun Lu
MGMing-Rong Guo
Ming-Rong Guo
YDYong-Qi Dai
Yong-Qi Dai
QWQiang Wang
Qiang Wang
HLHu Luo
Hu Luo