The dominating catalytic approach to aromatic hydrocarbons from renewables, deoxygenation of phenol-rich depolymerized lignin bio-oils, is hard to achieve: hydrodeoxygenation (HDO) of phenols typically leads to the loss of aromaticity and to non-negligible fractions of cyclohexanones and cyclohexanols. Here, we report a catalyst, niobia-supported iridium nanoparticles (Ir@Nb2O5), which combines full conversion in the HDO of lignin-derived phenols with appreciable and tunable selectivity for aromatics (25-95%) under mild conditions (200-300 °C, 2.5-10 bar of H2). A simple approach to the removal of Brønsted-acidic sites via Hünig's base prevents coking and allows reaction conditions (T > 225 °C, 2.5 bar of H2), promoting high yields of aromatic hydrocarbons.
Due to environmental concerns regarding single-use plastic materials, major efforts are being made to develop new material concepts based on biodegradable and renewable resources, e.g., wood pulp. In this study, we assessed two types of wood pulp fibres, i.e., thermomechanical pulp (TMP) and Kraft pulp fibres, and tested the performance of the fibres in wet-moulding and thermopressing trials. Kraft pulp fibres appeared to retain more water than TMP, increasing the dewatering time during wet-moulding and apparently increasing the compression resistance of the pulp during thermoforming. Additionally, cellulose nanofibres (CNF) were added to the pulps, which improved the mechanical properties of the final thermopressed specimens. However, the addition of CNF to the pulps (from 2 to 6%) had a further decrease in the dewatering efficiency in the wet-moulding process, and this effect was more pronounced in the Kraft pulp specimens. The mechanical performance of the thermoformed specimens was in the same range as the plastic materials that are conventionally used in food packaging, i.e., modulus 0.6–1.2 GPa, strength 49 MPa and elongation 6–9%. Finally, this study demonstrates the potential of wood pulps to form three-dimensional thermoformed products.
This study follows the generation of microfibrils from kraft pulp, by fractioning ten samples extracted from commercial mechanically produced cellulose nanofibrils (mech-CNFs). SEM and AFM imaging revealed that during mechanical treatment, the outer cell wall (P and S 1 ) and/or possible parts of S 2 -layer, detaches from the fibre structure as ribbons and flakes, but can also remain partially attached with the fibre core. Further processing induces internal fibrillation in the flakes and ribbons, resulting in the delamination and formation of microfibrils. These microfibrils can still be attached to the fibre structure. Interesting properties were shown for what would be considered very coarse fibres. This improves knowledge on mech-CNF production and provides further understanding of mech-CNF interactions in different applications.