Efficient simultaneous transmission of light with a power of more than 2 W at a wavelength of 976 nm and an optical carrier for transmitting a high-frequency analog signal at a wavelength of 1550 nm over a distance of 1 km over a standard single-mode fiber was experimentally demonstrated. Electrical power up to 350 mW (5 V, 70 mA) was obtained from a multi-junction silicon photocell, resulting in the optical transmission efficiency of about 70% and a photocell efficiency of 25%. The power transmission did not affect the transmission of the high frequency analog signal. Key broadband analog transmission characteristics such as noise figure (NF < 25 dB) and spurious-free dynamic range (SFDR3 > 117 dB/Hz2/3) were achieved and were close to the fundamental shot noise limit. This approach is promising for powering a remote antenna unit in optical fronthaul architecture.
The possibility of correcting the power coupling ratio of an integrated optical directional X-coupler upon excitation of a local photorefractive response in the substrate material (LiNbO3)...
The mechanism of enhancing the interaction of optical radiation with a superconducting niobium nitride film on the surface of optical waveguides on a lithium niobate substrate using an additional cover layer with a high refractive index has been studied. It has been shown that adiabatic deformation of waveguide modes allows increasing the absorption of light in a superconducting film to the level of ∼1 dB/μm, which makes it possible to manufacture a single photon detector with a quantum efficiency of about 70% on lithium niobate.
A system for integrated optical LiNbO3 Mach–Zehnder modulator operating point remote control and stabilization was developed. It consisted of a conventional telecom photodiode and a passive electronic circuit at the bias input of the modulator. Light from an amplitude-modulated laser was used to remotely set the output voltage of the electronic circuit at the bias input of the Mach–Zehnder modulator. Information regarding the current operating point that had been provided with feedback system implementation was taken from DC values of high frequency photodetector currents. Efficient remote control of the modulator operating point over 1 km of a single-mode optical fiber, which multiplexes an optical carrier at 1550 nm and a low frequency control signal with a peak power of 2 mW at 1310 nm, was demonstrated. The results could be of interest for antenna remoting, radio-over-fiber (RoF) technology, and other applications with broadband optical transmission from remote sources in a distributed network.
An approach for filtering the fundamental mode in an integrated optical modulator with multimode waveguides based on etched thin lithium niobate nanofilms is presented. It is shown that metal electrodes can be used as a modal filter to suppress high-order modes in wide multimode ridge waveguides and, consequently, to provide their quasi-single-mode regime of operation. The influence of the gap between the electrodes and its displacement relative to the waveguide symmetry axis is analyzed for various configurations of waveguides. The conditions for quasi-single-mode light propagation with suppression of high-order modes of more than 90 dB/cm are found. The influence of fabrication errors on the efficiency of modal filtering is discussed. Efficient electro-optical modulation with an equivalent voltage-length product of 4 V∙cm has been experimentally demonstrated on integrated optical phase modulator samples fabricated using conventional contact photolithography. The proposed topological solution can be further used for the fast and cheap fabrication of TFLN modulators by conventional contact photolithography. The proposed modal filtering can also be used in other waveguide topologies and in more complex waveguide devices.