Alessandro Talamelli

Prof. Alessandro Talamelli


Research Focus & Metrics

Academic Career Length

31Years (1996-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 April 2006 in Flow, Turbulence and Combustion
Verified
Journal Article
Closed access
PDF file
ATAlessandro Talamelli
Alessandro Talamelli
IGIsabella Gavarini
Isabella Gavarini

23 April 2019 in Journal of Fluid Mechanics
Verified
Journal Article
Closed access
PDF file
SZS. Zimmerman
S. Zimmerman
JPJ. Philip
J. Philip
JMJason Monty
Jason Monty
ATAlessandro Talamelli
Alessandro Talamelli
IMIvan Marusic
Ivan Marusic
JKJ. Klewicki
J. Klewicki
This study presents findings from a first-of-its-kind measurement campaign that includes simultaneous measurements of the full velocity and vorticity vectors in both pipe and boundary layer flows under matched spatial resolution and Reynolds number conditions. Comparison of canonical turbulent flows offers insight into the role(s) played by features that are unique to one or the other. Pipe and zero pressure gradient boundary layer flows are often compared with the goal of elucidating the roles of geometry and a free boundary condition on turbulent wall flows. Prior experimental efforts towards this end have focused primarily on the streamwise component of velocity, while direct numerical simulations are at relatively low Reynolds numbers. In contrast, this study presents experimental measurements of all three components of both velocity and vorticity for friction Reynolds numbers $Re_{\unicode[STIX]{x1D70F}}$ ranging from 5000 to 10 000. Differences in the two transverse Reynolds normal stresses are shown to exist throughout the log layer and wake layer at Reynolds numbers that exceed those of existing numerical data sets. The turbulence enstrophy profiles are also shown to exhibit differences spanning from the outer edge of the log layer to the outer flow boundary. Skewness and kurtosis profiles of the velocity and vorticity components imply the existence of a ‘quiescent core’ in pipe flow, as described by Kwonet al. (J. Fluid Mech., vol. 751, 2014, pp. 228–254) for channel flow at lower $Re_{\unicode[STIX]{x1D70F}}$ , and characterize the extent of its influence in the pipe. Observed differences between statistical profiles of velocity and vorticity are then discussed in the context of a structural difference between free-stream intermittency in the boundary layer and ‘quiescent core’ intermittency in the pipe that is detectable to wall distances as small as 5 % of the layer thickness.

3 June 2017 in Meccanica
Verified
Journal Article
Closed access
PDF file
CBCarlo A. Borghi
Carlo A. Borghi
ACAndrea Cristofolini
Andrea Cristofolini
GNGabriele Neretti
Gabriele Neretti
PSPaolo Seri
Paolo Seri
ARAlessandro Rossetti
Alessandro Rossetti
ATAlessandro Talamelli
Alessandro Talamelli

24 June 2025 in Journal of Fluid Mechanics
Verified
Journal Article
Open access
PDF file
GDGiulio Dacome
Giulio Dacome
LLLorenzo Lazzarini
Lorenzo Lazzarini
ATAlessandro Talamelli
Alessandro Talamelli
GBGabriele Bellani
Gabriele Bellani
WBWoutijn Baars
Woutijn Baars
An experimental study was conducted in the CICLoPE long-pipe facility to investigate the correlation between wall-pressure and turbulent velocity fluctuations in the logarithmic region, at high friction Reynolds numbers ( $4794 \lesssim Re_\tau \lesssim 47\,015$ ). Hereby, we explore the scalability of employing wall-pressure to effectively estimate off-the-wall velocity states (e.g. to be of use in real-time control of wall-turbulence). Coherence spectra for wall-pressure and streamwise (or wall-normal) velocity fluctuations collapse when plotted against $\lambda _x/y$ and thus reveals a Reynolds-number-independent scaling with distance-from-the-wall. When the squared wall-pressure fluctuations are considered instead of the linear wall-pressure term, the coherence spectra for the wall-pressure-squared and velocity are higher in amplitude at wavelengths corresponding to large-scale streamwise velocity fluctuations (e.g. at $\lambda _x/y = 60$ , the coherence value increases from roughly 0.1 up to 0.3). This higher coherence typifies a modulation effect, because low-frequency content is introduced when squaring the wall-pressure time series. Finally, quadratic stochastic estimation is employed to estimate turbulent velocity fluctuations from the wall-pressure time series only. For each $Re_\tau$ investigated, the estimated time series and a true temporal measurement of velocity inside the turbulent pipe flow yield a normalised correlation coefficient of $\rho \approx 0.6$ for all cases. This suggests that wall-pressure sensing can be employed for meaningful estimation of off-the-wall velocity fluctuations and thus for real-time control of energetic turbulent velocity fluctuations at high- $Re_\tau$ applications.

18 November 2022 in Energies
Verified
Journal Article
Open access
PDF file
Francesco MazzeoFrancesco Mazzeo
Francesco Mazzeo
DMDerek Micheletto
Derek Micheletto
ATAlessandro Talamelli
Alessandro Talamelli
Antonio SegaliniAntonio Segalini
Antonio Segalini
An experimental and numerical investigation about the pitch imbalance effect on a wind turbine model is performed. The characterization of the power losses and loads generated on a small-scale model and the validation of an analytical framework for the performance of unbalanced rotors are proposed. Starting from the optimal collective pitch assessment (performed to identify the condition with the maximum power coefficient), the pitch of just one blade was systematically changed: it is seen that the presence of a pitch misalignment is associated with a degradation of the turbine performance, visible both from experiments and from Blade Element Momentum (BEM) calculations (modified to account for the load asymmetry). Up to 30% power losses and a 15% thrust increase are achievable when an imbalanced rotor operates at tip speed ratios around five, clearly highlighting the importance of avoiding this phenomenon when dealing with industrial applications. The numerical model predicts this result within 5% accuracy. Additional numerical simulations showed that, away from the optimal collective pitch, the blade imbalance can provide a power increase or a power decrease with respect to the balanced case, suggesting how an operator can maximise the production of an unbalanced rotor. An analysis of the axial and lateral forces showed a sensitivity of the loads’ standard deviation when imbalance is present. An increase of the lateral loads was observed in all unbalanced cases.

9 April 2013 in Experiments in Fluids
Verified
Journal Article
Closed access
PDF file
ATAlessandro Talamelli
Alessandro Talamelli
ASAntonio Segalini
Antonio Segalini
Ramis ÖrlüRamis Örlü
Ramis Örlü
PSPhilipp Schlatter
Philipp Schlatter
HAHenrik Alfredsson
Henrik Alfredsson