Global warming and environmental pollution from greenhouse gas emissions are hitting an all-time high consistently year after year. In 2022, energy-related emissions accounted for 87% of the overall global emissions. The fossil fuel-based conventional power systems also need timely upgrades to improve their cycle efficiency and reduce their impact on the environment. Supercritical CO2 systems and cycles are gaining attention because of their higher efficiencies and their compatibility with varied energy sources. The present work is a detailed overview of the recent developments in supercritical CO2-based power generation technologies. The supercritical CO2-based Brayton and Rankine power cycles and their improvisations in industrial applications are also discussed in detail. The advances in heat exchanger technology for supercritical CO2 systems are another focus of the study. The energy, exergy, and economical (3E) analysis is carried out on various supercritical CO2 power cycles reported in the literature and the data are concisely and intuitively presented. The review concludes by listing the identified directions for future technology development and areas of immediate research interest. A roadmap is proposed for easing the commercialization of supercritical CO2 technologies to immediately address the growing challenges and concerns arising from energy-related emissions.
Solar assisted trigeneration system has proved to be a potential method in generating power with net zero carbon emissions. The present work aims to address the potential ways to improve the efficiency of the solar energy-integrated carbon dioxide trigeneration system. A regeneration integrated combined cooling, heating, and power system is proposed. With a comprehensive thermodynamic model, the proposed system is simulated for various operating conditions. A component-level exergy analysis is also conducted to estimate the total irreversibility of the system. As the gas cooler exit temperature increases, the overall system irreversibility also increases. When the bleed mass is 20% of the total mass, the system has the lowest energy destruction rate. The potential component that contributes most to system irreversibility is the gas cooler, followed by the regenerator and expansion valve. The proposed system with regeneration yields 29% more COP than the conventional system when operating at lower compressor discharge pressure and a gas cooler exit temperature of 34 °C. It is inferred from the obtained results that to reduce the total irreversibility of the system, it is advised to operate the system at a lower compressor discharge pressure and gas cooler exit temperature.
Transcritical carbon dioxide (CO2) refrigeration and air conditioning systems employing ejector-expansion cycles offer enhanced refrigerating effects and reduced compressor power, resulting in improved coefficient of performance. This study presents the influence of the collector duct on the performance of the two-phase CO2 parallel ejector. A three-dimensional (3D) computational fluid dynamics (CFD) analysis based on homogeneous equilibrium model (HEM) was employed and the simulations were carried out for two higher ambient operating conditions. Flow parameters such as Mach number, enthalpy, and vapour quality distribution were analysed in order to get more insight into the flow physics and to capture the realistic flow behaviour of two-phase CO2 inside the ejector. Results reveal that including the collector duct give rise to recirculation and flow separation zones in the collector duct’s flow domain for ejector’s that are positioned close to and away from the collector outlet. However, the centrally positioned ejector reported uniform flow behaviour and a performance improvement of 21% while comparing to its without collector duct configuration. This study aims to bridge the gap between geometrically reduced models and practical ejector configurations by analysing the realistic two-phase ejector flow dynamics and provides valuable insights for optimizing parallel ejector modules in CO2 refrigeration and air conditioning systems.