The extraction efficiency of petroleum‐derived dissolved organic matter (DOM) was examined for groundwater samples from an aquifer contaminated with crude oil. Five different types of extraction techniques were investigated to determine which method is best suited for the analysis of potentially toxic petroleum‐derived DOM. The five types were a liquid‐liquid extraction (LLE) with dichloromethane (DCM) and total petroleum hydrocarbons‐diesel range (TPH d ) with DCM (EPA method 3510C), and three solid‐phase extraction (SPE) stationary phases that are routinely used for extraction of polar analytes from water. For the LLE and TPH d , that is selective for nonpolar compounds, the extraction efficiency of petroleum‐derived DOM decreased downgradient as the petroleum‐derived DOM becomes increasingly polar due to biodegradation. In contrast, the average extraction efficiency by the SPE methods was greater than 65% across the gradient. The results showed that SPE is more efficient for extracting petroleum‐derived DOM at hydrocarbon‐contaminated sites. The use of a method with greater extraction efficiency for partially oxidized hydrocarbons may prove useful in determining relationships between their composition and structure and potential for risks to human health or the environment.
15 September 2023 in Journal of Hazardous Materials
The short- and long-term impacts of nanoparticles (NPs) in consumer products are not fully understood. Current European Union (EU) regulations enforce transparency on products containing NPs in cosmetic formulations; however, those set by the U.S. Food and Drug Administration are lacking. This study demonstrates the potential of single-particle inductively coupled plasma tandem mass spectrometry (spICP-MS/MS) as a screening method for NPs present in powder-based facial cosmetics (herein referred to as FCs). A proposed spICP-MS/MS method is presented along with recommended criteria to confirm particle presence and particle detection thresholds in seven FCs. FC products of varying colors, market values, and applications were analyzed for the presence of Bi, Cr, Mg, Mn, Pb, Sn, Ag, Al, and Zn NPs based on their ingredient lists as well as those commonly used in cosmetic formulations. The presence of NPs smaller than 100 nm was observed in all FC samples, and no correlations with their presence and market value were observed. Here, we report qualitative and semi-quantitative results for seven FC samples ranging in color, brand, and shimmer.