Finite-state model predictive control (FS-MPC) is computationally expensive, as it uses all voltage vectors available for prediction and estimation. This study proposes a novel finite-state model-based predictive current control (MPCC) scheme to overcome the drawbacks of FS-MPC. A reference frame based on the prediction of the current locus when a zero-voltage vector is employed is established to reduce the computational requirements; specifically, only one zero-voltage vector must be predicted compared to the seven required in conventional FS-MPC. The selection of the optimal voltage vector is based on the direction of the current locus in the established reference frame instead of a cost function, which is necessary and time consuming in conventional FS-MPC. Zero-voltage vectors are also selected by contrasting the distance between the reference and predictive currents to reduce the torque ripple of the proposed method. Simulation and experimental results are presented and confirm the efficient performance of the proposed MPCC.
Flow field optimization plays a vital role in improving the output performance of proton exchange membrane fuel cells (PEMFCs), especially at high current density. A streamline dot flow field is proposed in this study to enhance the mass transfer of reactant gas and compared it with parallel, rectangular dot, and rhombic dot flow fields. The influence of the tail length of streamline dot block on the performance of fuel cells is further analyzed. The results show that the uniform distributions of pressure and oxygen molar fraction are significantly increased in dot flow fields compared with parallel flow field. In dot flow fields, vortices produced behind the dot blocks could increase the flow resistance and pressure drop. Among six models, the dot flow field with 2 mm tail has the most uniform current density distribution at PEM-CL cross section, and its index of uniformity current density (IUCD) is the smallest with the value of 0.012991. And the parallel flow field model has the largest value of IUCD. Compared with parallel flow field, the current density of streamline dot flow field model with 2 mm tail increased by 4.9%.
AgNbO3-based materials have attracted extensive attention in energy storage due to their double hysteresis loops, but they suffer from low breakdown strength (Eb). AgNbO3 films with few defects and small thickness exhibit high Eb, which helps to improve the energy storage performance. In this work, we successfully prepared AgNbO3 thin films on (110) SrTiO3 substrate using pulsed laser deposition technology. The AgNbO3 film shows good crystalline and relaxor ferroelectric behavior. A high Eb up to 1200 kV/cm is obtained in AgNbO3 film, which contributes to good recoverable energy storage density Wrec up to 10.9 J/cm3 and energy efficiency η of 75.3%. Furthermore, the Wrec remains above 2.9 J/cm3 and the η varies between 72.5% and 82.5% in a wide temperature range of 30–150 °C. This work reveals the great potential of relaxor ferroelectric AgNbO3 film for energy storage.