Transparent conductive coatings based on thin films of metal oxides are widely used in various optoelectronic devices and appliances. The article is devoted to the study of the morphological, structural, electrical and optical properties of transparent conductive oxide. Tin dioxide thin films are obtained by spray pyrolysis technique on glass substrates. Analysis of the structural properties showed that SnO2 has a tetragonal crystal structure. Analysis of the morphological properties showed that the grain size of the films increases at a deposition temperature from 450 to 550 ℃. Dependencies of the transmittance coefficient of samples obtained on the solutions volume and transmittance coefficient of samples obtained on the doping levels have become the result of studying the optical properties of transparent conductive oxide. The transmittance is almost independent on the amount of substance sprayed onto the substrate. However, the transmittance is greatly influenced by the chemical composition of the films. The main electrical parameter affecting the TCO quality is conductivity or surface resistance. Surface resistance is measured by probe methods, the most accurate of which is the Van der Pauw method. Surface resistance consistently decreases with increasing solution volume, precursor concentration and impurity concentration.
A technique is proposed for controlling the temporal instability of the dielectric parameters of ferroelectrics, which allows the critical number of polarization switching cycles to be calculated. The technique makes it possible to exclude the metrological failure of functional electronic elements based on the investigated materials because of their dielectric fatigue.
1 August 2017 in IOP Conference Series: Materials Science and Engineering
Transparent conductive coatings based on thin films of metal oxides have been widely spread in various optoelectronic devices and appliances. It is necessary to determine the influence of preparation conditions on coatings properties for their use in the solution of certain tasks. Thin films of tin dioxide were obtained by the method of spray pyrolysis on glass substrates. Surface resistance and resistivity, concentration and mobility of charge carriers, the conductivity were measured, and the dependences showing the effect of preparation conditions on electrical properties of optically transparent coatings.
The structure of a measuring unit as a part of hardware and software complex for measurement and control of the parameters of ferroelectrics and products based on them is examined. This complex allows to measure automatically dielectric parameters depending on the electric field tensity and the temperature, to control the temporary instability of the residual polarization.