In the current paper, a new hybrid nanofluid based on graphene oxide sheets and silicon nanoparticles is proposed for thermal applications. GO sheets and Si nanoparticles with different mixture ratios are dispersed in distilled water. Dynamic viscosity is measured at temperatures within the range 20–50 °C and the values are compared to the results available in the literature. The results indicated that the viscosity increases with increasing the mixture ratio of graphene oxide. A new correlation for the dynamic viscosity based on the experimental findings is proposed. Finally, the criteria for the performance of new hybrid nanofluid for thermal applications are analyzed.
1
30 January 2025 in International Journal of Thermophysics
In the last years, studies have demonstrated the potential of hybrid nanofluids to enhance the performance of direct absorption solar collectors. These working fluids containing noble metals (gold, silver) are known for their local surface plasmon resonance which is the main cause for the increased absorption within the solar spectrum. In the current paper, new direct absorption solar collectors prototypes using water-ethylene glycol solution and 0.1 wt.% silver nanoparticles + reduced graphene oxide dispersed in water-ethylene glycol mixture were designed, built, and tested under outdoor conditions, at two flow rates (1.0 and 1.5 l·min−1) and two inlet temperatures (20 $$^\circ{\rm C}$$ and 30 $$^\circ{\rm C}$$ ), over several days in September 2023, at Brasov, Romania. The results suggested that by using silver nanoparticles + reduced graphene oxide nanofluid, the efficiency is improved related to water-ethylene glycol solution. The maximum relative enhancement in efficiency was 16.72% related to the base fluid. Also, at 1.0 l·min−1, the instantaneous and accumulative energies delivered were about 13.51% and 42.91%, respectively, higher than the water-ethylene glycol solution. Finally, the current results were compared to other research carried out on full-scale direct absorption solar collectors tested in outdoor conditions.
The main goal of the present study was to prepare and also to investigate the effects of both temperature and weight concentration on the thermo-physical properties of γ-Fe2O3/water nanofluids. The γ-Fe2O3 nanoparticles were synthesized by laser pyrolysis technique and characterized using TEM, XRD, and EDX techniques. Thermal conductivity, viscosity and surface tension of γ-Fe2O3/water nanofluids were investigated within the range of the temperature of 20°C to 70°C for various weight concentrations of nanoparticles (0.5, 1.0, 2.0, and 4.0 wt%). The experimental results show that the thermal conductivity ratio is much higher than of thermal conductivity of base fluid. Thus, the relative thermal conductivity was 59% for a concentration of 4.0 wt% and a temperature of 50°C. Also, it has been observed that the influence of weight concentration of nanoparticles on viscosity was lower at temperatures over 55°C. At standard temperature of 25°C and 2.0 wt.% concentration of nanoparticles, the relative dynamic viscosity was 5.61%. Experimental results show that the surface tension increases with increase of weight concentrations and decreases with increase of temperatures. For a temperature of 70°C and 2.0 wt.% concentration of nanoparticles, the relative surface tension was 46%. The experimental results were compared with data available in literature.
12 April 2010 in SAE International Journal of Advances and Current Practices in Mobility
In this paper, using the facilities offered by the ANSYS CFX, CFD code, the authors investigate numerically the flow around the Ahmed body for the rear slanted upper surface of 35°, fitted with a simple underbody diffuser, without endplates, in order to find the influence of the later one on the main aerodynamic characteristics, drag and lift. Relative motion between body and ground is simulated. The study is performed for different geometrical configurations, length and the angle of the diffuser being the parameters which are varied in ranges which are relevant for hatchback passenger cars. Later, based on a theoretical approach, a coefficient of the equivalent hydraulic resistance of the diffuser is computed, which helps to evaluate the drag due to underbody diffuser.
11 November 2020 in International Journal of Thermophysics