This study justifies the prospect of using aerial imagery from unmanned aerial vehicles (UAVs) for technological monitoring and operational control of municipal solid waste landfills. It presents the results of surveys (aerial imagery) of a number of Russian landfills, which were carried out using low-cost drones equipped with standard RGB cameras. In the processing of aerial photographs, both photogrammetric data processing algorithms (for constructing orthophotoplans of objects and 3D modeling) and procedures for thematic interpretation of photo images were used. Thematic interpretation was carried out based on lists of requirements for the operating landfills (the lists were compiled on the basis of current legislative acts). Thus, this article proposes framework guidelines for the complex technological monitoring of landfills using relatively simple means of remote control. It shows that compliance with most of the basic requirements for landfill operations, which are listed in both Russian and foreign regulation, can be controlled by unmanned aerial imagery. Thus, all of the main technological operations involving waste at landfills (placement, compaction, intermediate isolation) are able to be controlled remotely; as well as compliance with most of the design and planning requirements associated with the presence and serviceability of certain engineering systems and structures (collection systems for leachate and surface wastewater, etc.); and the state of the landfill body. Cases where the compliance with operating standards cannot be monitored remotely are also considered. It discusses the advantages of air imagery in comparison with space imagery (detail of images, operational efficiency), as well as in comparison with ground inspections (speed, personnel safety). It is shown that in many cases, interpreting the obtained aerial photographs for technological monitoring tasks does not require special image processing and can be performed visually. Based on the analysis of the available world experience, as well as the results of the study, it was concluded that unmanned aerial imagery has great potential for solving problems of waste landfill management.

This article describes the process of integrating one of the most commonly used laser methane detectors, the Laser Methane mini (LMm), and a multi-rotor unmanned aerial vehicle (UAV) based on the Pixhawk flight controller to create an unmanned aerial system designed to detect methane leakages from the air. The integration is performed via the LaserHub+, a newly developed device which receives data from the laser methane detector, decodes it and transmits it to the flight controller with the protocol used by the ArduPilot platform for laser rangefinders. The user receives a single data array from the UAV flight controller that contains both the values of the methane concentrations measured by the detector, and the co-ordinates of the corresponding measurement points in three-dimensional space. The transmission of data from the UAV is carried out in real time. It is shown in this project that the proposed technical solution (the LaserHub+) has clear advantages over not only similar serial commercial solutions (e.g., the SkyHub complex by SPH Engineering) but also experimental developments described in the scientific literature. The main reason is that LaserHub+ does not require a deep customization of the methane detector or the placement of additional complex devices on board the UAV. Tests using it were carried out in aerial gas surveys of a number of municipal solid waste disposal sites in Russia. The device has a low cost and is easy for the end user to assemble, connect to the UAV and set up. The authors believe that LaserHub+ can be recommended as a mass solution for aerial surveys of methane sources. Information is provided on the approval of LaserHub+ for aerial gas surveys of a number of Russian municipal waste disposal facilities.