The paper presents the damage and typological classification for the cultural heritage asset proposed in the PERPETUATE Project funded by the...

There are many existing buildings for which seismic rehabilitation interventions are required, especially in earthquake-prone areas like Italy. At the same time, the huge energy cost increase in Europe highlights the need for sustainable techniques that are able to increase the energy efficiency of buildings. These issues are even more significant for weak social groups living in social housing buildings, often in poor and vulnerable conditions. In order to address the solution regarding building renovations from the social, structural, and energy efficiency perspectives, in the framework of the Horizon Europe REHOUSE (Renovation packagEs for HOlistic improvement of EU’s bUildingS Efficiency, maximizing RES generation and cost-effectiveness) Project, this paper proposes an integrated methodology of building assessment that was tested on a social housing building in Margherita di Savoia, a small town of Apulia Region, Italy. In addition to the structural and energy aspects, the social one is particularly important since the building is located in the “Capitanata Area”, considered to be one of the most socially vulnerable areas in Italy. For this reason, an assessment methodology must consider reducing the overall impact of the assessment activities while explaining to tenants the purpose of the assessment and future renovation actions, maintaining the accuracy of the assessment results. Therefore, this study outlines an assessment methodology, demonstrated through its application to the case study building, that integrates the structural, energy, and social aspects, showing that the tenants’ involvement is also crucial for the technical evaluations. The final result is a low-impact approach for the building knowledge gathering needed to start a deep renovation intervention in social housing.

The corrosion behavior of certain steels under extremely oxidative conditions, simulating the impact of water radiolysis on stainless steels, has been investigated. Radiolysis generates aggressive species, including radicals, solvated electrons, and hydrogen peroxide, potentially leading to corrosion over time in materials typically considered resistant. To expedite the kinetics of this phenomenon, drastic conditions were employed, involving high concentrations of peroxide in a strongly acidic environment. Under these conditions, corrosion can manifest rapidly. The varied responses of different steels are contingent upon their inherent nature and chemical composition, notably the chromium and nickel content. Steels with higher chromium and nickel concentrations exhibit increased resistance to corrosion, even in such severe environments. Microscopic corrosion mechanisms involve pitting and intergranular corrosion. Pitting results in the formation of craters on surfaces, while intergranular corrosion leads to the detachment of grains.

This chapter provides a contribute for the critical comparison between standard values and field analysis data, achieved from tests performed within a widespread research activity on the Abruzzo architectural heritage, since the 2009 L'Aquila earthquake. The seismic Italian code prescribes that the masonry mechanical characterisation must be defined on the basis of available data analysis, visual investigation and in-situ experimental tests. The seismic Italian Technical Codes for Construction requires the assessment of the safety levels before/after any intervention on existing constructions, taking into account the seismic improvement or the local strengthening of the building. The selection of the appropriate methodology for the seismic vulnerability evaluation is dictated by the building type. Specific diagnostic procedures, consisting in the application of standardised testing sets, have been developed, with the purpose of optimising the number of measures to reach the knowledge levels required by the Italian code.

Na₂MoO₄ and Na₂WO₄ are isostructural semiconductors, belonging to the spinel class. They have interesting properties and find applications in numerous sectors. These properties can be tuned by controlling the composition of their solid solutions. Here, different methods to obtain these compounds are presented, both wet and solid-state synthesis. The obtained results show a possible dependence of the material properties on the chosen synthesis method. The pure compounds and their mixtures were characterized by Raman spectroscopy, scanning electron microscopy, and X-ray diffraction.