We present algorithms of the channel and carrier frequency offset (CFO) estimation for burst-mode continuous phase modulation (CPM) transmission with optimized training waveforms, which are obtained through minimizing the Cramer-Rao bound (CRB). Wirtinger calculus, which provides a framework for complex-valued signal processing, is used to simplify the derivations of CRBs and maximum likelihood estimation. Unlike linear modulation, the training waveform is optimized not only with respect to the modulated training sequence but also the sampling delay and sampling rate due to the continuous phase of CPM waveforms. In order to reduce the computation complexity of the optimization, we derive a closed-form expression for efficient computation of the objective function. The numerical results demonstrate the significant performance improvement of the optimized waveforms compared to the training sequences of previous works. Based on that, we propose two schemes for CFO estimation. The first scheme is a suboptimal maximum likelihood estimation of the CFO and it achieves a better trade-off between the estimation accuracy and complexity compared to optimal maximum likelihood estimation. The second scheme is based on the channel estimation, which leads to much lower implementation complexity than the other estimators. Finally, the measured bit error rate reveals the considerable gain of the estimation algorithm with the optimized training waveform.
Abstract— We propose a simplified decision-directed synchronization algorithm for continuous phase modulation based on the linear approximation to the phase of the CPM signal. It yields simple and practical synchronization algorithm with closed-loop architecture, in which the derivative matched filters are not required. Numerical results demonstrate that this novel synchronizer achieves improved timing estimation performance while requiring lower complexity when compared to the well-known method based on pulse amplitude modulation approximation. The demodulation architecture with the proposed algorithm is presented, and its bit error rate (BER) approaches the theoretical bound.
In this study, they authors introduce a suboptimal training sequence for burst‐mode continuous phase modulation. The optimum training sequence has been prove to be optimal for the estimates of carrier frequency offset, carrier phase error and timing error. However, the optimum sequence brings high side‐lobe of the log‐likelihood function (LLF), that is not benefit for detecting the start of the sequence (SOS). Thus, the suboptimal sequence is designed to improve the SOS performance through decreasing the side‐log effect of the LLF. Meanwhile, the proposed sequence can minimise the Cramer‐Rao bound for the joint estimation of carrier frequency offset, carrier phase error and symbol timing error. The data‐aided maximum likelihood algorithms for timing error and phase error estimation are derived for evaluating the performance of the proposed sequence. The simulation results demonstrate that the new sequence provides better performance on start detection of the sequence than the optimal one. The performance of timing and carrier phase recovery is also close to the ideal synchronisation performance.
Multi-h continuous phase modulation (CPM), with extremely high spectral efficiency, involves the plague of high demodulation complexity with a large number of matched filters and a complex trellis. In this paper, an efficient all-digital demodulator for multi-h continuous phase modulation (CPM) is proposed based on a low-complexity decision-directed synchronization algorithm. Based on the maximum-likelihood estimation of the carrier phase and timing errors, we propose a reduced-complexity timing error detector with linear phase approximation (LPA) to the phase of the multi-h CPM. Compared with the traditional synchronization methods, it avoids derivative matched filtering and reduces about 2/3 of matched filters. The estimated accuracy and bit error rate (BER) performance of the LPA-based synchronization algorithm have no loss, as shown by the numerical simulation. Its stability is verified by the derived S-curve. Then, the receivers with the LPA-based synchronization for the three kinds of promising multi-h CPM are implemented on a Xilinx Kintex-7 FPGA platform. The experimental results show that the onboard tested BER of the proposed design has an ignorable loss in the numerical simulation. The implementation overhead on FPGA is significantly reduced by about 27% slices, 64% DSPs, and 70% block RAMs compared with the conventional method.
21 September 2012 in Circuits, Systems, and Signal Processing