The 2021 Yangbi Ms 6.4 earthquake in Yunnan, China, occurred in an area where the Global Positioning System (GPS) geodetic observations are particularly intensive. Based on a detailed retrospective analysis of the GPS observations of about 133 stations distributed in the proximately 400 km × 400 km region that contains the area affected by the earthquake., we obtain a high-resolution GPS velocity field and strain rate field and then derive the present-day slip rates of major faults in the region with the commonly used half-space elastic dislocation model and constraints from the GPS velocity field. Furthermore, by calculating the seismic moment accumulation and release and deficit rates in the main fault segments and combining with the distribution characteristics of small earthquakes, we evaluate the regional seismic risk. The results show that (1) there was a localized prominent strain accumulation rate around the seismogenic area of the impending Yangbi Ms 6.4 earthquake, although this was not the only area with a prominent strain rate in the whole region. (2) The seismogenic area of the earthquake was just located where the strain direction was deflected, which, together with the localized outstanding maximum shear strain and dilatation rates, provides us with important hints to determine the potential areas of future strong earthquakes. (3) Of all the seismogenic fault segments with relatively high potentials, judged using the elapsed time of historical earthquakes and effective strain accumulation rate, the middle section of the Weixi–Qiaohou fault has a higher earthquake risk than the southern section, the Midu–Binchuan section of the Chenghai fault has a higher risk than the Yongsheng section and the Jianchuan section of the Jianchuan–Qiaohou–Lijiang–Xiaojinhe fault has a higher risk than the Lijiang section.
While seasonal hydrological mass loading, derived from Gravity Recovery and Climate Experiment (GRACE) measurements, shows coherent spatial patterns and is an important source for the common mode error (CME) in continuous global positioning system (cGPS) measurements in Yunnan, it is a challenge to quantify local effects and detailed changes in daily GPS measurements by using GRACE data due to its low time and spatial resolutions. In this study, we computed and compared two groups of CMEs for nine cGPS sites in the northwest Yunnan province; rCMEs were computed with the residual cGPS time series having high inter-station correlations, while oCMEs were computed with all the GPS time series. The rCMEs-filtered time series had smaller variances and larger root mean square (RMS) reductions than those that were oCMEs-filtered, and when the stations local effects were not removed, spurious transient-like signals occurred. Compared with hydrological mass loading (HYDL), its combination with non-tidal atmosphere pressure and ocean mass reached a better agreement with the CME in the vertical component, with the Nash–Sutcliffe efficiency (NSE) increasing from 0.28 to 0.55 and the RMS reduction increasing from 15.19% to 33.4%, respectively. Our results suggest that it is necessary to evaluate the inter-station correlation and remove the possible noisy stations before conducting CME filtering, and that one should carefully choose surface loading models to correct the raw cGPS time series if CME filtering is not conducted.
On 17 November 2017, a Mw 6.5 earthquake occurred in Mainling County, Nyingchi City, China. The epicenter was located in the Namche Barwa region of the eastern Himalayan syntaxis. Here, we have derived coseismic deformation from Global Positioning System (GPS) data and ascending Sentinel-1A Synthetic Aperture Radar (SAR) data. Based on a joint inversion of the two datasets, we obtained the coseismic slip distribution along a curved, northeast trending, and high-angle (dip angle of 75°) thrust fault. Our results show that the seismic moment release was 7.49 × 1018 N∙m, corresponding to a moment magnitude of Mw 6.55. The maximum slip was 1.03 m and the main rupture zone extended to a 12 km depth. The earthquake may have been related to the release of strain accumulated during the subduction of the Indian plate beneath the Eurasian continent. We identified a high strain rate and low b-values around the epicentral area before the earthquake, indicating that the earthquake was nucleated under a high strain/stress state. The data indicate two regions, southwest and southeast to the epicenter (the eastern Main Himalaya Thrust and northern end of the Sagaing fault), which remain under high stress/strain conditions and pose a significant seismic hazard.
The 2021 6.4 Yangbi earthquake, Yunnan, China, was recorded by the Dali Global Positioning System (GPS) network comprising 37 permanent stations within 100 km of the epicenter. All of these GPS stations recorded 1 Hz data, and 12 of them also recorded 5 Hz data. Using sophisticated data processing strategies, especially the method to overcome ionospheric and multipath errors, near‐field waveforms of epoch‐by‐epoch displacement of all of the GPS stations within an epicentral distance of ∼50 km were derived from high‐rate GPS observations with a root mean square error of 3.8, 4.2, and 8.2 mm for the east–west, north–south, and up components, respectively. The peak ground displacement of up to 14 cm in the horizontal direction and 4.2 cm in the vertical direction and the largest coseismic displacement of 3.1 cm in the horizontal direction and 3.2 cm in the vertical direction were observed for the stations within 6–9 km of the epicenter. The waveforms, with dominant periods between 7 and 10 s, present a systematic change in shape as a function of distance from the source, which demonstrates that the high‐rate GPS observations can provide reliable relative‐displacement response spectra at the periods needed in the design of large structures for resisting strong earthquakes. Comparisons of the GPS displacement time series at 1, 2.5, and 5 Hz suggest that 5 Hz data are able to capture strong ground information that are of interest to both earthquake seismologists and engineers. We conclude that the displacement waveforms and motion trajectories from high‐rate GPS observations provide unique additional information of the near‐field strong ground motion that is valuable to seismologists in unraveling the dynamic process of fault rupture and to engineers for designing large structures with very long period response.
On 21 May 2021, an Mw 6.1 earthquake occurred in Yangbi County, Dali Bai Autonomous Prefecture, Yunnan Province, with the epicenter located in an unmapped blind fault approximately 7 km west of the Weixi-Qiaohou fault (WQF) on the southeastern margin of the Qinghai–Tibetan Plateau. While numerous studies have been conducted to map the coseismic slip distribution by using the Global Navigation Satellite System (GNSS), Interferometric Synthetic Aperture Radar (InSAR) and seismic data as well as their combinations, the understanding of deformation characteristics during the postseismic stage remains limited, mostly due to the long revisiting time interval and large uncertainty of most SAR satellites. In this study, we refined coseismic slip and afterslip distributions with nonlinear inversions for both fault geometry and relaxation time. First, we determined the fault geometry and coseismic slip distribution of this earthquake by joint inversion for coseismic offsets in the line-of-sight (LOS) direction of both Sentinel-1A/B ascending and descending track images and GNSS data. Then, the descending track time series of Sentinel-1 were further fitted using nonlinear least squares to extract the coseismic and postseismic deformations. Finally, we obtained the refined coseismic slip and afterslip distributions and investigated the spatiotemporal evolution of fault slip by comparing the afterslip with aftershocks. The refined coseismic moment magnitude, which was of Mw 6.05, was smaller than Mw 6.1 or larger, which was inferred from our joint inversion and previous studies, indicating a significant reduction in early postseismic deformation. In contrast, the afterslip following the mainshock lasted for about six months and was equivalent to a moment release of an Mw 5.8 earthquake. These findings not only offer a novel approach to extracting postseismic deformation from noisy InSAR time series but also provide valuable insights into fault slip mechanisms associated with the Yangbi earthquake, enhancing our understanding of seismic processes.
9 September 2022 in Seismological Research Letters