Khulud Habanjar

Dr. Khulud Habanjar


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 May 2020 in Applied Physics A
Verified
Journal Article
Closed access
PDF file
KHKhulud Habanjar
Khulud Habanjar
HSHaneen Shehabi
Haneen Shehabi
AAA. M. Abdallah
A. M. Abdallah
RAR. Awad
R. Awad

1 October 2020 in Materials Research Express
Verified
Journal Article
Open access
MAMohammed Almoussawi
Mohammed Almoussawi
AAA M Abdallah
A M Abdallah
KHKhulud Habanjar
Khulud Habanjar
RAR Awad
R Awad
(Sm, Co) co-doped ZnO nanoparticles (Zn1−2xSmxCoxO), 0.00 ≤ x ≤ 0.06 , have been prepared by the co-precipitation technique. The effect of the dopant ions Sm3+ and Co2+ on the structural, morphological, and electrical conductivity of ZnO has been studied. XRD analysis shows the substitution of Zn2+ ions by the co-doping Sm3+ and Co2+ ions with the formation of secondary phases as Sm2O3 and Co3O4 upon 0.005 co-doping and above. Raman spectra showed the characteristic mode of the wurtzite structure of ZnO nanoparticles with a vibration assigned to the bound of Co with the donor defects at high doping level of (Sm, Co). The spherical morphology of pure ZnO is transformed into nanorods as the concentration of Sm3+ and Co2+ increases. From EDX spectra, it was shown that all samples exhibit an excellent compositional homogeneity that verifies the Sm and Co presence as real dopants in ZnO crystalline structure. FTIR spectra show one discrete peak at 417 cm−1 with another broad peak at 568 cm−1corresponding to Zn–O stretching, which confirms the formation of the wurtzite structure of the samples. Photoluminescence studies reveal the existence of minor defects in the co-doped samples. The study proposes the suitable use of the samples in the high-efficiency UV light-emitting devices due to the intense UV peaks compared with the lower visible peaks. The excitation dependent PL spectra demonstrated a redshift with increasing the excitation wavelength accounting for the distribution of energetic species in the ground state. The DC electrical conductivity is enhanced with (Sm, Co) co-doping of x = 0.1 due to the formation of thermally activated donor levels.

31 October 2023 in Applied Physics A
Verified
Journal Article
Closed access
PDF file
MSMajed Sharrouf
Majed Sharrouf
RAR. Awad
R. Awad
KHKhulud Habanjar
Khulud Habanjar

17 April 2024 in Applied Physics A
Verified
Journal Article
Closed access
PDF file
HKHani Korek
Hani Korek
KHKhulud Habanjar
Khulud Habanjar
RAR. Awad
R. Awad

12 May 2021 in Journal of Physics: Condensed Matter
Verified
Journal Article
Closed access
FFFarah Fattouh
Farah Fattouh
LRLama Rifai
Lama Rifai
KHKhulud Habanjar
Khulud Habanjar
AAA M Abdallah
A M Abdallah
RHR Sayed Hassan
R Sayed Hassan
RARamadan Awad
Ramadan Awad
Hard-soft nanocomposites of (1 − x ) BaFe 12 O 19 / x (Zn 0.5 Co 0.5 )Fe 2 O 4 , for x = 0.00, 0.25, 0.50, 0.75 and 1.00, were prepared via co-precipitation and high-speed ball milling techniques, respectively. The synthesized samples were characterized via x-ray diffraction, transmission electron microscope, Fourier transform infrared (FTIR), and vibrating sample magnetometer. XRD revealed the formation of hard-soft nanocomposites. TEM indicated that the two phases are well distributed and the particle size distribution is narrower for low content of soft phase, leading to better exchange coupling between the grains. Magnetic measurements were performed at 300 K and 77 K. The results showed a good single-phase magnetic behavior, verifying the good exchange coupling between hard and soft phases. For low (Zn 0.5 Co 0.5 )Fe 2 O 4 content, the dipolar interactions were dominated by the exchange-coupling interactions. Additionally, the optimum values of saturation and remanent magnetizations, coercivity, and squareness ratio were obtained for x = 0.5. This was attributed to the dominance of exchange-coupling interaction. The enhancement of magnetic properties and energy product ( BH ) max for nanocomposites at low temperature is skilled in the reduction of the thermal fluxes of magnetic moments at the surface. The maximum energy product ( BH ) max was observed in C2 at both temperatures with a smaller value than that of pure BaFe 12 O 19 .

2 February 2024 in Physica Scripta
Verified
Journal Article
Closed access
HKHani Korek
Hani Korek
KHKhulud Habanjar
Khulud Habanjar
RAR Awad
R Awad
Cadmium zinc ferrites Cd0.5Zn0.5SmxFe2−xO4 nanoparticles were synthesized with different concentrations x = 0.00, 0.01, 0.02, 0.04, 0.06, and 0.08, via the wet chemical co-precipitation method. The effects of the Sm3+ doping on the structural, morphological, compositional, and magnetic properties have been investigated. The structural analysis is performed using x-ray diffraction (XRD) with Rietveld refinement. The results indicate great crystallinity in the FCC Fd3m spinel structure of Cd0.5Zn0.5SmxFe2−xO4 nanoparticles. The crystallite size was estimated using Debye–Scherrer, Williamson–Hall, Size-strain plot (SSP), and Halder-Wagner (H-W) methods. It revealed a decreasing trend with the increase of Sm-doping concentrations until the solubility limit at around x = 0.04. The spherical morphology of the samples was investigated using transmission electron microscopy (TEM) with minor agglomeration as a benefit of using the capping agent polyvinylpyrrolidone (PVP). Raman spectroscopy validates the incorporation of trivalent Sm3+ in the octahedral sites. X-ray photoelectron spectroscopy (XPS) verified the elemental compositions as well as the purity of the samples and the incorporation of the dopants. A vibrating sample magnetometer (VSM) was used to study the magnetic properties, and which indicates the superparamagnetic behavior of the prepared samples. The prepared samples were tested as liquefied petroleum gas (LPG) sensors by studying their sensitivity, optimum working temperature, response time, and recovery time. The doping of samarium ions reveals a great increase in LPG sensing sensitivity and optimum temperature with decreasing response and recovery times.