Between 1 September and 4 October 2014, a combined airborne and ground-based measurement campaign was conducted to study tropical deep convective clouds over the Brazilian Amazon rain forest. The new German research aircraft, High Altitude and Long Range Research Aircraft (HALO), a modified Gulfstream G550, and extensive ground-based instrumentation were deployed in and near Manaus (State of Amazonas). The campaign was part of the German–Brazilian Aerosol, Cloud, Precipitation, and Radiation Interactions and Dynamics of Convective Cloud Systems–Cloud Processes of the Main Precipitation Systems in Brazil: A Contribution to Cloud Resolving Modeling and to the GPM (Global Precipitation Measurement) (ACRIDICON– CHUVA) venture to quantify aerosol–cloud–precipitation interactions and their thermodynamic, dynamic, and radiative effects by in situ and remote sensing measurements over Amazonia. The ACRIDICON–CHUVA field observations were carried out in cooperation with the second intensive operating period of Green Ocean Amazon 2014/15 (GoAmazon2014/5). In this paper we focus on the airborne data measured on HALO, which was equipped with about 30 in situ and remote sensing instruments for meteorological, trace gas, aerosol, cloud, precipitation, and spectral solar radiation measurements. Fourteen research flights with a total duration of 96 flight hours were performed. Five scientific topics were pursued: 1) cloud vertical evolution and life cycle (cloud profiling), 2) cloud processing of aerosol particles and trace gases (inflow and outflow), 3) satellite and radar validation (cloud products), 4) vertical transport and mixing (tracer experiment), and 5) cloud formation over forested/deforested areas. Data were collected in near-pristine atmospheric conditions and in environments polluted by biomass burning and urban emissions. The paper presents a general introduction of the ACRIDICON– CHUVA campaign (motivation and addressed research topics) and of HALO with its extensive instrument package, as well as a presentation of a few selected measurement results acquired during the flights for some selected scientific topics.

Aerosol particles were collected aboard two Brazilian Bandeirante EMB 110 planes, and the University of Washington Convair C‐131A aircraft during the Smoke, Clouds, and Radiation‐Brazil (SCAR‐B) field project in the Amazon Basin in August and September 1995. Aerosols were collected on Nuclepore and Teflon filters. Aerosol size distribution was measured with a MOUDI cascade impactor. Sampling was performed mostly over areas heavily influenced by biomass burning smoke. Particle‐induced X ray emission (PIXE) was used to measure concentrations of up to 20 elements (Al, Si, P, S, Cl, K, Ca, Ti, V, Cr, Mn, Fe, Ni, Cu, Zn, Br, Rb, Sr, Zr, and Pb). Black carbon (BC) and gravimetric mass analysis were also performed. Instrumental neutron activation analysis (INAA) determined the concentrations of about 15 elements on the Teflon filters. Electron probe X ray microanalysis (EPMA) was used to analyze individual aerosol particles. The average aerosol mass concentration was 105 μg m⁻³, with a maximum of 297 μg m⁻³. Black carbon (BC) averaged 5.49 μg m⁻³, or 1–7% of the aerosol mass load. Five aerosol components were revealed by absolute principal factor analysis: (1) a biomass burning component (responsible for 54% of the aerosol mass and associated with BC, K, Cl, Zn, I, S, Br, Rb, aerosol mass concentration, and other elements); (2) a soil dust aerosol component (15.6% of the aerosol mass); (3) a natural biogenic component (18.7% of the aerosol mass and associated with P, K, S, Ca, Sr, Mg, Mn, Cu and Zn); (4) a second soil dust (5.7% of the aerosol mass and enriched in Si, Ti, and Fe); and (5) a NaCl aerosol component (5.9% of the aerosol mass with Na, Cl, Br, and iodine). Electron microscopy analysis of individual aerosol particles confirmed these five aerosol types. Organic material dominated the aerosol mass and the number concentration of airborne particles. Aerosol size distributions show that the fine mode accounts for 78% of the aerosol mass, centered at 0.33 μm aerodynamic diameter. The coarse mode accounts for 22% of the mass, centered at about 3.2 μm. Black carbon size distributions show a consistent picture, with a mass median diameter centered at about 0.175‐0.33 μm aerodynamic diameter. This study suggests that for modeling the optical properties of aerosol in the Amazon Basin, it is essential to use a model that includes the optical and physical properties of at least two aerosol components other than the biomass burning aerosol, namely, natural biogenic aerosol and soil dust.