Guide vane submersible centrifugal pumps are a kind of submersible pump, and the fluid inside the pump is often mixed with gravel and other impurities during operation, affecting the pump’s operating efficiency and life expectancy. However, past studies on solid–liquid two-phase flow (STF) and wear characteristics in guided vane centrifugal pumps have been limited to the particle trajectory and wear region distribution. These studies have lacked research on the effect of particles on the fluid flow and the specific amount of wear on the overflow components. Additionally, most of them have used the DPM discrete-phase model, which does not consider the particle–particle and particle–wall interactions. This paper is based on the CFD–DEM method, combined with the Archard wear model. A solid–liquid two-phase flow simulation is carried out for pumps with different particle sizes and particle shapes to analyze the particle movement inside the pump, the wear distribution and average wear amount of the overflow components, and the effect of particles on the turbulent kinetic energy of the fluid. The results show that the particles mainly collide with the leading and trailing edges of the impeller blades and the leading edge of the guide vane blades and form a buildup at the trailing edge of the concave surface of the guide vane blades, resulting in the wear being mainly distributed in these regions. With an increase in particle size and a decrease in sphericity, the average wear on the overflow components increases. The change of particle size directly affects the resistance of the fluid and the structure of the flow field, which has a large impact on the fluid flow pattern and generates large turbulent kinetic energy fluctuations. The shape of the particles only changes the structure of the local flow field, which has a small impact on the fluid flow pattern.
The methodologies of computational fluid dynamics (CFD) and response surface method (RSM) were integrated to uncover the optimal correlational framework for intricate hydraulic geometric parameters of guide vane centrifugal pumps. Parameters such as blade number, blade wrap angle, blade outlet angle, and relative axial distance between the guide vane and impeller, as well as radial distance, are embraced as optimization design variables. Meanwhile, pump head and efficiency were chosen as responsive variables. An analysis of 46 sets of hydraulic performance data was carried out by using the Box–Behnken experimental design method. Subsequently, response surface approximation models were established between hydraulic parameters and the efficiency, as well as the head. The optimal design point was predicted and a simulation of the hydraulic characteristics for the optimal scheme was conducted; the errors were 0.846% for head and 0.256% for efficiency between the simulation results with predicted results from RSM. The optimized model demonstrates noteworthy enhancements in hydraulic performance in comparison to the original model. By analyzing the internal flow of the optimized model under transient conditions, it was found that, as the internal flow of the flow passage components is relatively disordered at small flow rates, the amplitude of pressure pulsation is affected a lot. At other flow rates, the inside pressure pulsation waveform exhibits pronounced periodicity, and the primary causes of pressure pulsation in various flow components are not the same. Wall dissipation and turbulent dissipation emerge as significant contributors to the entropy generation in this centrifugal pump. The magnitude of entropy generation is correlated with the flow rate and the structural configuration of the pump’s components. High-entropy regions concentrate around the leading and trailing edges of the blades.