In this work, the effect of the presence of a heat source and its location on natural convection in a C-shaped enclosure saturated by a nanofluid is investigated numerically using the lattice Boltzmann method. Fifteen cases consisting of different heat source locations attached to an isolated wall of the enclosure have been considered to achieve the best configuration at different Rayleigh numbers (103-106) and various solid volume fractions of the nanofluid (0-0.05). Results are shown in terms of the streamlines, isothermal lines, velocity profiles, and the local and average Nusselt numbers. The numerical solution is benchmarked against published results from previous studies for validation, and a good agreement is demonstrated. According to the results, at Ra = 103, the maximum Nusselt number is achieved when the heat source is located within the upper horizontal cavity. Moreover, at higher Rayleigh numbers (Ra = 106) and locations of the heat source within the vertical cavity yield the best Nusselt numbers. Compared to the base fluid and at low Rayleigh numbers, the increase in the Nusselt number of the nanofluid is not found to be dependent on the location of the heat source. However, for high Rayleigh numbers, the maximum increase is obtained when the heat source is located in the upper part of the vertical.
22 February 2019 in Journal of Thermal Analysis and Calorimetry
In this paper, the laminar forced convection heat transfer of nanofluid through a bent channel was numerically investigated. The lattice Boltzmann method was used for solving the governing equations in the domain. The effect of different parameters such as Reynolds number (50 ≤ Re ≤ 150), vertical passage ratio (2.0 ≤ M ≤ 4.0), and nanoparticle solid volume fractions (Φ = 0, 0.01, 0.03, 0.05) are analyzed in terms of streamlines, isotherms, and local Nusselt numbers. It was concluded from this study that the local and average Nusselt number increased with increasing nanoparticle volume fraction regardless of Re and M. Moreover, the effect of the nanofluid concentration on the increment of heat transfer was more remarkable at higher values of the Reynolds number. Simulations show that by increasing the Reynolds number or decreasing the vertical passage ratio, the local and average Nusselt number increases.
1 December 2018 in Journal of the Taiwan Institute of Chemical Engineers