Unconventional reservoir has become the hotspot of development in petroleum industry. In shale reservoir, some fracture is only propped by a monolayer 100mesh proppant. Fracture width is very small and under the condition of low rock hardness and high effective closure stress, the fracture will heal after a period of time, especially after the rock has been exposed to the fracturing fluids, causing weakening of the rock frame. In these reservoirs, proppant embedment becomes more serious. This paper purposes two embedment mechanisms, elastic deformation and creep deformation, and develops the corresponding models by combining simplified physical processes with elastic theory. Then with time integral, pressure dependent embedment depth is achieved. This paper provides a more reasonable method for calculating embedment. For fracturing engineer, it will give them a way to know how worse the matter will be. Finally, the model could couple with fracture propagation model and production prediction model to get a better result. According to the results of analysis in the paper, in shale formation, proppant will cause creep deformation of rock, which will decrease fracture width with time. Optimization of fracturing fluid and treatment procedure are required to reduce the influence of creep deformation. Poisson's Ratio do have an effect on proppant embedment but very little. The mechanisms described in the paper provide a new understanding about embedment. It provides us a tool to determine how much the degree will be.
1 January 2022 in Journal of Petroleum Science and Engineering
Igneous rock oil and gas reservoirs have great development potential. Hydraulic fracturing is an important means for the development of these reservoirs. In the process of fracturing and increasing production, fracturing fluid is prone to a hydration reaction with clay minerals in igneous rock, and then, the structure and mechanical properties of the igneous rock are changed, affecting increased production. Therefore, it is necessary to establish a systematic water–rock reaction experiment method to understand the influence of fracturing fluid on the structure and mechanical properties of igneous rocks and to optimize the fracturing fluid system of igneous rock reservoirs. In this experiment, four solutions were used: slickwater, guar fracturing fluid, 2% KCl aqueous solution, and 4% KCl aqueous solution. Acoustic testing, porosity and permeability testing, XRD analysis, micro-CT scanning, and displacement experiments were performed. The influence of different fracturing fluids on the structure and mechanical properties of igneous rocks was studied. Igneous rock samples with a permeability of 0.05–0.1 mD and average porosity of 7–14% were used. The results show that all four liquid systems will reduce the permeability, Young’s modulus, and brittleness index and increase the porosity and Poisson’s ratio of the rock after fracturing. Among them, the permeability damage rate is as high as 37.37%, which may be related to the plugging of pores with solid residues in the gel breaking liquid; CT results show that there are microcracks in the rock, which increase over time, up to 13.54%. The brittleness index decreases. Among the fluids, the influence of slickwater on the rock brittleness index is the smallest, no more than 5%. Guar gum had the greatest effect on the Gel breaking liquid, up to 58%. One of the reasons for the increase in porosity is that adding a clay stabilizer composed of inorganic salts and organic cationic polymers to the slickwater fracturing fluid can effectively reduce the damage caused by the fracturing fluid to the rock during the fracturing process and can reduce the maximum by 50%. This paper can clarify the damage law of fracturing fluid systems to igneous rock reservoirs and provide the theoretical basis for the hydraulic fracturing of igneous rock reservoirs.