The phase mixing of Alfvén waves is one of the most promising mechanisms for the heating of the solar atmosphere. The damping of waves in this case requires small transversal scales, relative to the magnetic field direction; this requirement is achieved by considering a transversal inhomogeneity in the equilibrium plasma density profile. Using a single-fluid approximation of a partially ionized chromospheric plasma, we study the effectiveness of the damping of phase-mixed shear Alfvén waves and investigate the effect of varying the ionization degree on the dissipation of waves. Our results show that the dissipation length of shear Alfvén waves strongly depends on the ionization degree of the plasma, but more importantly, in a partially ionized plasma, the damping length of shear Alfvén waves is several orders of magnitude shorter than in the case of a fully ionized plasma, providing evidence that phase mixing could be a large contributor to heating the solar chromosphere. The effectiveness of phase mixing is investigated for various ionization degrees, ranging from very weakly to very strongly ionized plasmas. Our results show that phase-mixed propagating Alfvén waves in a partially ionized plasma with ionization degrees in the range μ = 0.518–0.657, corresponding to heights of 1916–2150 km above the solar surface, can provide sufficient heating to balance chromospheric radiative losses in the quiet Sun.
This article presents an analytical and numerical investigation on the quasi-steady, slow flow generated by the movement of a micropolar fluid drop sphere of at a concentrical position within another immiscible viscous fluid inside a spherical slip cavity. Additionally, the effect of a cavity with slip friction along with the change in the micropolarity parameter on the movement of the fluid sphere is introduced. When Reynolds numbers are low, the droplet moves along a diameter that connects their centres. The governing and constitutive differential equations are reduced to a computationally convenient form using appropriate transformations. By using the resulting linear partial differential equations for the stream functions and using the method of separation variables, we can obtain their solutions. General solutions for velocity fields are found using spherical coordinate systems, which are based on the concentric point of the cavity; this allows to obtain solutions to the Navier-Stokes equations internal and external to the spherical droplet. The vorticity-microrotation boundary condition is used in regard to the micropolar droplet case in a viscous fluid. The normalised drag forces acted upon the micropolar drop are illustrated via graphs and tables for diverse values of the viscosity ratio and drop-to-wall radius ratio, with the change of the spin parameter that attaches the microrotation to vorticity. The correction wall factor is shown to increase with an increase in the drop-to-wall radius ratio, when moving from the gas bubble case to the solid sphere case, with an increase in the micropolarity parameter, and with an increase in the slip frictional resistance. This study is relevant due to its potential uses in a variety of biological, natural, and industrial processes, including the creation of raindrops, the investigation of blood flow, fluid-fluid extraction, the forecasting of weather conditions, the rheology of emulsions, and sedimentation phenomena.
In this paper, an analytical and numerical technique are examined in order to analyse the Stokes flow determination problem due to a viscous sphere droplet moving at a concentric instantaneous position inside a spherical interface separating finite and semi-infinite immiscible fluid phases. Here, when only one of the three phases of the fluid (micropolar fluid) has a microstructure, attention is focused on this case. The motion is considered when Reynolds- and capillary-numbers are low, and the droplet surface and the fluid-fluid interface have insignificant deformation. A general solution is obtained in a spherical coordinate system based on a concentric position to analyse the slow axisymmetric movement of the micropolar fluid, considering microrotation and velocity components. Boundary conditions are initially fulfilled at the fluid-fluid interface and subsequently at the droplet surface. The normalised hydrodynamic drag force applying to a moving viscous droplet appears to be a function of the droplet-to-interface radius ratio, which increases monotonically and becomes unbounded when the droplet surface touches the fluid-fluid interface. The numerical outcomes of the normalised drag force acting on the viscous droplet are derived for different values of the parameters, and are presented in a tabular and graphical framework. A comparison was made between our numerical outcomes for the drag force and the pertinent data for the special cases found in the literature.
This paper presents a comprehensive mathematical model for analyzing the dynamics of illicit drug consumption within a population. Building upon and extending classical epidemiological models such as the susceptible, infected, and recovered (SIR) framework, the proposed model categorizes individuals into four compartments: Non-susceptible, susceptible, addicted, and rehabilitated. The model incorporates key social factors such as peer influence, intervention efforts, and the probability of relapse. A nonlinear system of differential equations was developed to describe the transitions between these states. The basic reproduction number $ R_0 $ was derived to assess the potential spread of addiction and stability analysis of the equilibrium points was carried out. Numerical simulations explore the impact of various intervention levels, highlighting how increased societal and family involvement can reduce the prevalence of addiction. Furthermore, an optimal control problem was formulated and solved using Pontryagin's maximum principle to determine the most cost-effective intervention strategy over time. The results demonstrate that adaptive, well-balanced policies can significantly reduce both susceptibility and addiction rates while minimizing social and economic costs.
This study thoroughly examined the complex electro-magnetohydrodynamic (EMHD) boundary layer flow of ternary hybrid nanofluids (THNP), specifically, Ti 6Al4V-ZnO-Fe2O3, over stretching-shrinking and permeable surfaces, and recognized the important impact of the nonlinear Darcy-Forchheimer law and thermal radiation. The THNP, comprised of three distinct nanoparticles including: titanium alloy Ti6Al4V (6% aluminum, 4% vanadium, balance titanium), zinc oxide ZnO, and iron oxide Fe2O3 suspended in a base fluid, is used to enhance both thermal and flow properties. The model comprehensively addressed inertial effects in porous media through the Darcy-Forchheimer drag, as well as the electromagnetic forces and thermal radiation. The governing partial differential equations were transformed into nonlinear ordinary differential equations via similarity transformations, which were solved through an intelligent numerical approach using artificial neural networks (ANN). A thorough analysis was conducted on the effect of important parameters such as the Darcy-Forchheimer permeability, nanoparticle volume fractions, stretching/shrinking rates, surface permeability, and radiation intensity on the velocity and temperature profiles. The results are shown graphically and discussed, providing insight related to the fluid dynamics and heat-transfer phenomena in such advanced systems.