An electrochemical hydrogen pump (EHP) with a proton exchange membrane (PEM) used as part of fusion cycle systems successfully combines the processes of hydrogen extraction, purification and compression in a single device. This work comprises a novel study of the effect of ionizing radiation on the properties of the PEM as part of the EHP. Radiation exposure leads to nonspecific degradation of membranes, changes in their structure, and destruction of side and matrix chains. The findings from this work reveal that the replacement of sulfate groups in the membrane structure with carboxyl and hydrophilic groups leads to a decrease in conductivity from 0.115 to 0.103 S cm−1, which is reflected in halving the device performance at a temperature of 30 °C. The shift of the ionomer peak of small-angle X-ray scattering curves from 3.1 to 4.4 nm and the absence of changes in the water uptake suggested structural changes in the PEM after the irradiation. Increasing the EHP operating temperature minimized the effect of membrane irradiation on the pump performance, but enhanced membrane drying at low pressure and 50 °C, which caused a current density drop from 0.52 to 0.32 A·cm−2 at 0.5 V.
The activities of Pt electrocatalysts modified with a prepared silica powder (with SiO2 contents of 3 and 7 wt%) in the oxygen reduction reaction in the temperature range from 0 °C to 50 °C were investigated by the rotating disk electrode technique to evaluate their efficiency in the process of the cold start of a proton-exchange membrane fuel cell (PEMFC). An increase in the mass activity of the Pt-SiO2/C electrocatalyst in comparison with Pt/C was observed, which can be attributed to a more dispersed distribution of platinum particles on the support surface and a decrease in their size. The activity values of the silica-modified electrocatalysts in the oxygen reduction reaction were approximately two-fold higher at 1 °C and four-fold higher at elevated temperatures of up to 50 °C in comparison with Pt/C, which makes their application in PEMFCs at low temperatures, including in the process of cold start, a promising avenue for further investigation.
In this work, a multicomponent platinum electrocatalyst supported on carbon (PtX/(SbY + SnO2Z)/C) was synthesized for the oxygen reduction reaction (ORR) and methanol oxidation reaction (MOR) for a proton exchange membrane fuel cell (PEMFC). Specific surface area analysis and scanning electron microscopy studies confirmed the incorporation of antimony and tin dioxide nanoparticles into the electrocatalyst structure. Electrochemical studies made it possible to differentiate the contribution of the modifiers to the characteristics of the modified electrocatalyst. Due to the incorporation of tin dioxide, the specific activity values in the oxygen reduction and methanol oxidation reactions exceed those of the unmodified samples by 40 and 36%, respectively. The introduction of antimony contributed to the retention of high electrochemical characteristics (20% less loss of active surface area) upon exposure to catalytic poisons by increasing electrical conductivity. The multicomponent electrocatalyst is also characterized by a 2.8-fold increase in stability and an electrochemically active surface area comparable to that of a commercial sample.
10 April 2026 in International Journal of Hydrogen Energy