Hiroshi Kimura

Dr. Hiroshi Kimura

orcid

Research Focus & Metrics

Academic Career Length

35Years (1992-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2014
Verified
Conference Paper
Closed access
HKHiroshi Kimura
Hiroshi Kimura
PAPervez Aziz
Pervez Aziz
TJTai Jing
Tai Jing
ASAshutosh Sinha
Ashutosh Sinha
RNRam Narayan
Ram Narayan
FZFreeman Zhong
Freeman Zhong
A high-speed SerDes must meet multiple challenges including high-speed operation, intensive equalization technique, low power consumption, small area and robustness. In order to meet new standards, such a OIF CEI-25G-LR, CEI-28G-MR/SR/VSR, IEEE802.3bj and 32G-FC, data-rates are increased to 25 to 28Gb/s, which is more than 75% higher than the previous generation of SerDes. For SerDes applications with several hundreds of lanes integrated in single chip, power consumption is very important factor while maintaining high performance. There are several previous works at 28Gb/s or higher data-rate [1-2]. They use an unrolled DFE to meet the critical timing margin, but the unrolled DFE structure increases the number of DFE slicers, increasing the overall power and die area. In order to tackle these challenges, we introduce several circuits and architectural techniques. The analog front-end (AFE) uses a single-stage architecture and a compact on-chip passive inductor in the transimpedance amplifier (TIA), providing 15dB boost. The boost is adaptive and its adaptation loop is decoupled from the decision-feedback equalizer (DFE) adaptation loop by the use of a group-delay adaptation (GDA) algorithm. DFE has a half-rate 1-tap unrolled structure with 2 total error latches for power and area reduction. A two-stage sense-amplifier-based slicer achieves a sensitivity of 15mV and DFE timing closure. We also develop a high-speed clock buffer that uses a new active-inductor circuit. This active-inductor circuit has the capability to control output-common-mode voltage to optimize circuit operating points.

6 July 2025 in Fluids
Verified
Journal Article
Open access
PDF file
HKHiroshi Kimura
Hiroshi Kimura
HTHaruka Tanabe
Haruka Tanabe
SSSusumu Shinoki
Susumu Shinoki
Smectite clay minerals are known to readily form thixotropic physical gels in aqueous media, even at low volume fractions. Although the rheological properties of these gels are closely related to the microstructure of the network, the influence of the clay’s physicochemical characteristics remains insufficiently understood. In this study, we systematically investigated the relationships between particle size, cation exchange capacity, and zeta potential, and the rheological behavior of aqueous dispersions of four synthetic smectites. After thorough deionization, dispersions were prepared at controlled NaCl concentrations. We found that the zeta potential strongly correlates with the fineness of the network structure and governs macroscopic rheological responses such as viscosity, yield stress, and gelation behavior. Even under identical conditions, gel transparency and structural coarseness varied significantly among clay types. Furthermore, the storage modulus was influenced not only by network density but also by the intrinsic stiffness of the clay branches. These findings demonstrate that zeta potential serves as a unified indicator of structure and function in smectite dispersions and offer useful insights for gel design in colloidal and soft matter systems.

1 January 1992 in Materials Science Forum
Verified
Journal Article
Closed access
PDF file
SKS. Kobayashi
S. Kobayashi
HKHiroshi Kimura
Hiroshi Kimura

1 March 2021 in Behavioural Brain Research
Verified
Journal Article
Closed access
MNMasahito Nangaku
Masahito Nangaku
KYKouhei Yoshino
Kouhei Yoshino
YOYasunori Oda
Yasunori Oda
MKMakoto Kimura
Makoto Kimura
HKHiroshi Kimura
Hiroshi Kimura
MIMasaomi Iyo
Masaomi Iyo

13 June 2024 in Materials
Verified
Journal Article
Open access
PDF file
HKHiroshi Kimura
Hiroshi Kimura
The sol–gel state of smectite clay dispersions varies with the volume fraction of clay and electrolyte concentration. In this study, it was elucidated that the drying patterns of droplets from four types of smectite clay dispersions vary according to their sol–gel states. Droplets in the sol state exhibited a ring-shaped pattern, while those in the gel state showed a bump-shaped pattern. Near the boundary between the sol and gel states, patterns featuring both ring and bump structures were observed regardless of whether the droplets were on the sol or gel side. When guest particles or molecules were introduced into the clay dispersion, they dispersed uniformly within the system, and the drying pattern depended on the sol–gel state of the droplets. These findings suggest that the presence or absence of convection within the droplets during drying governs the drying pattern.

1 June 1998 in Journal of Molecular Histology
Verified
Journal Article
Closed access
PDF file
TDTakashi Doi
Takashi Doi
KTKazuhiro Terai
Kazuhiro Terai
Ikuo TooyamaIkuo Tooyama
Ikuo Tooyama
TSToshiie Sakata
Toshiie Sakata
HKHiroshi Kimura
Hiroshi Kimura