The goal of this field study was to obtain a detailed account of wind erosion processes within a single agricultural field during a regional dust storm in the Southern High Plains of West Texas. The field, located in Wolfforth, Texas, was observed as the wind grew in strength, peaked, and later weakened. Sediment transport was monitored by an array of samplers spaced across the field, and meteorological information was obtained from a 10-m tower erected within the field. Erosion activity was monitored by a piezoelectric sensor that responded to the impact of saltating grains and provided a means for detecting the threshold of soil movement. Attempts were made to relate the observed temporal and spatial variations of sediment transport to meteorological factors and surface conditions. The results indicate that at the beginning of the storm, threshold was around 7 to 8 m/s. As the storm progressed, threshold appeared to slowly shift downward with time, suggesting a surface that was becoming increasingly erodible. Mass flux measurements showed substantial temporal variations that reflected changes of wind strength and changes in surface erodibility. The pattern of mass flux variation across the field was dependent on the height of measurement. The near surface flow of saltating grains (z < 0.25 m) was found to vary according to surface conditions, especially surface roughness. At greater heights, the flow of fine dust was less affected by surface conditions immediately beneath the point of measurement. Within the fully developed surface layer (z < 0.25 m), the mass flux profile was found to follow a modified powerlaw function. The near surface mass flux consisted of a broad range of particle sizes ranging from 50 μm to 300 μm, whereas farther from the surface the mode shifted distinctly toward smaller particle sizes with few particles larger than 100 μm. We show that it is possible to display graphically the relative contribution of the various grain sizes to the mass flux at each height in a way that makes it possible to visualize the zones of saltation and suspension, and the region of transition between these regimes.
1 September 2012 in Journal of Soil and Water Conservation
Drought and high temperature are two major environmental factors that severely limit plant productivity in the United States and worldwide, often causing extensive economic loss to agriculture. As global climate change progresses, agricultural production worldwide faces serious threats from frequent extreme weather conditions. Integrated approaches that improve the efficiency of agricultural water use and development of plant varieties that can alleviate the negative impacts of environmental stresses to maintain yield stability are essential to sustain and increase agriculture production. Maize (Zea mays L.) is a major crop in the United States and worldwide. Its production and yield stability are greatly affected by drought and high temperature stresses. Improving drought and heat tolerance in maize has become one of the top priorities for maize breeding programs in both private and public sectors. Identification of maize germplasm with superior drought and/or heat tolerance is essential and prerequisite for such propose. In this report, we evaluated a selection of maize inbred lines for drought and heat stress tolerance under field conditions in 2009 and 2010 and identified several inbred lines that showed high tolerance to drought. Tolerant inbred lines (Tx205, C2A554-4, and B76) were able to maintain relatively high leaf relative water content when subjected to drought stress, while sensitive lines (B73 and C273A) showed a rapid reduction in leaf relative water content at very early stage of drought. The tolerant lines also showed significantly greater ability to maintain vegetative growth and alleviate damage to reproductive tissues under drought conditions compared to the sensitive lines. Maize inbred lines and hybrids were also evaluated for tolerance to high temperature under well-watered conditions through field observations following the occurrence of major heat events. Maize inbred lines of distinct heat tolerance phenotype were identified. Furthermore, genetic and phenotypic analysis showed that maize hybrids made from inbred lines with superior heat tolerance inherited an enhanced tolerance to elevated temperatures. The tolerant germplasm accessions, like those identified in this study, are essential materials for breeding drought- and/or heat-tolerant maize hybrids. Study for the potential use of such materials to produce maize hybrids that are able to alleviate the negative impacts of drought and heat stress on the growth and development of maize plants is underway.