Ilaria Zardo

Prof. Ilaria Zardo

orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
31 December 2009 in Physical Review B
Verified
Journal Article
Open access
PDF file
DSD. Spirkoska
D. Spirkoska
Jordi ArbiolJordi Arbiol
Jordi Arbiol
AGA. Gustafsson
A. Gustafsson
SCSonia Conesa-Boj
Sonia Conesa-Boj
FGF. Glas
F. Glas
AMA. Fontcuberta i Morral
A. Fontcuberta i Morral
The structural and optical properties of three different kinds of GaAs nanowires with 100% zinc-blende structure and with an average of 30% and 70% wurtzite are presented. A variety of shorter and longer segments of zinc-blende or wurtzite crystal phases are observed by transmission electron microscopy in the nanowires. Sharp photoluminescence lines are observed with emission energies tuned from 1.515 eV down to 1.43 eV when the percentage of wurtzite is increased. The downward shift of the emission peaks can be understood by carrier confinement at the interfaces, in quantum wells and in random short period superlattices existent in these nanowires, assuming a staggered band offset between wurtzite and zinc-blende GaAs. The latter is confirmed also by time-resolved measurements. The extremely local nature of these optical transitions is evidenced also by cathodoluminescence measurements. Raman spectroscopy on single wires shows different strain conditions, depending on the wurtzite content which affects also the band alignments. Finally, the occurrence of the two crystallographic phases is discussed in thermodynamic terms.

18 March 2013 in Nano Letters
Verified
Journal Article
Open access
SAS. Assali
S. Assali
IZIlaria Zardo
Ilaria Zardo
SPS. Plissard
S. Plissard
DKDominik Kriegner
Dominik Kriegner
MVMarcel A Verheijen
Marcel A Verheijen
EBE. P. A. M. Bakkers
E. P. A. M. Bakkers
The main challenge for light-emitting diodes is to increase the efficiency in the green part of the spectrum. Gallium phosphide (GaP) with the normal cubic crystal structure has an indirect band gap, which severely limits the green emission efficiency. Band structure calculations have predicted a direct band gap for wurtzite GaP. Here, we report the fabrication of GaP nanowires with pure hexagonal crystal structure and demonstrate the direct nature of the band gap. We observe strong photoluminescence at a wavelength of 594 nm with short lifetime, typical for a direct band gap. Furthermore, by incorporation of aluminum or arsenic in the GaP nanowires, the emitted wavelength is tuned across an important range of the visible light spectrum (555–690 nm). This approach of crystal structure engineering enables new pathways to tailor materials properties enhancing the functionality.

31 December 2009 in Physical Review B
Verified
Journal Article
Closed access
PDF file
IZIlaria Zardo
Ilaria Zardo
SCSonia Conesa-Boj
Sonia Conesa-Boj
FPFrancesca Peiro
Francesca Peiro
Juan Ramon MoranteJuan Ramon Morante
Juan Ramon Morante
Jordi ArbiolJordi Arbiol
Jordi Arbiol
AMA. Fontcuberta i Morral
A. Fontcuberta i Morral
Polarization-dependent Raman scattering experiments realized on single GaAs nanowires with different percentages of zinc-blende and wurtzite structure are presented. The selection rules for the special case of nanowires are found and discussed. In the case of zinc-blende, the transversal optical mode E1 (TO) at 267 cm−1 exhibits the highest intensity when the incident and analyzed polarization are parallel to the nanowire axis. This is a consequence of the nanowire geometry and dielectric mismatch with the environment, and in quite good agreement with the Raman selection rules. We also find a consistent splitting of 1 cm−1 of the E1 (TO). The transversal optical mode related to the wurtzite structure, E2H, is measured between 254 and 256 cm−1, depending on the wurtzite content. The azimuthal dependence of E2H indicates that the mode is excited with the highest efficiency when the incident and analyzed polarization are perpendicular to the nanowire axis, in agreement with the selection rules. The presence of strain between wurtzite and zinc-blende is analyzed by the relative shift of the E1 (TO) and E2H modes. Finally, the influence of the surface roughness in the intensity of the longitudinal optical mode on {110} facets is presented.

31 July 2015 in Nano Letters
Verified
Journal Article
Closed access
HHHåkon Ikaros T. Hauge
Håkon Ikaros T. Hauge
MVMarcel A Verheijen
Marcel A Verheijen
SCSonia Conesa-Boj
Sonia Conesa-Boj
TETanja Etzelstorfer
Tanja Etzelstorfer
MWMarc Watzinger
Marc Watzinger
EBErik P. A. M. Bakkers
Erik P. A. M. Bakkers

21 March 2013 in Nano Letters
Verified
Journal Article
Closed access
DRDaniel Rudolph
Daniel Rudolph
SFStefan Funk
Stefan Funk
MDMarkus Döblinger
Markus Döblinger
SMStefanie Morkötter
Stefanie Morkötter
SHSimon Hertenberger
Simon Hertenberger
GKGregor Koblmüller
Gregor Koblmüller

27 December 2010 in Applied Physics Letters
Verified
Journal Article
Closed access
MSMartin Soini
Martin Soini
IZIlaria Zardo
Ilaria Zardo
EUEmanuele Uccelli
Emanuele Uccelli
SFStefan Funk
Stefan Funk
GKGregor Koblmüller
Gregor Koblmüller
GAGerhard Abstreiter
Gerhard Abstreiter
The thermal properties of freely suspended GaAs nanowires are investigated by applying a method which relies on laser heating and the determination of the local temperature by Raman spectroscopy. In order to determine the values for the thermal conductivity κ, the fraction of the laser power absorbed inside the GaAs nanowire is estimated by numerical simulations. The thermal conductivity of nanowires with homogeneous diameter is found to lie in the range of 8–36 W m−1 K−1. The change of the temperature profile in the presence of a tapering was investigated. Furthermore, we discuss the influence of laser heating in ambient conditions on the value of κ.